772475
19
Zoom out
Zoom in
Previous page
1/40
Next page
17
2. Choose [Utilities], tap [OK].
3. Choose [Filament Loading], tap [OK]. 4. Choose [Load left], tap [OK].
5. Extruder starts to heat.
FF Creator Pro
Print from SD
Preheat
Utilities
Monitor
Filament Loading
Preheat Settings
General Settings
Unload right
Load right
Unload left
Load left
Heating:
Extruder: 26/230C
Press left to cancel
Withdraw
Filament
Guidetube
Withdraw
Filament
Press here
Please follow steps below if you need to unload filament in
daily use.
Unloading Filament
6. When heating to target temparture, press spring
presser and push filament down through for 3
seconds, then pull out vertically quickly and
release spring presser. Tap [OK], go back. Tap
leftwards arrow twice, go back to the home
screen.
1. Pull filament guidetube out of filament intake.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Flashforge Creator Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Flashforge Creator Pro in the language / languages: English as an attachment in your email.

The manual is 36.53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info