795099

Fito ASD-10 Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
PRODUCT WARRANTY
If used and maintained properly, the manufacturer gua-
rantees this product against material and/or manufacturing
faults for a period of 10 years from the original date of pur-
chase by the consumer. Exceptions include damage arising
from accidents or misuse. If the product becomes defective
within the stated period, then it will be repaired or replaced
free of charge. Please do not attempt to repair the product
yourself or tinker with it, which will invalidate the warranty.
MADE IN EUROPE
EUROPEAN SUPPLIER:
Fito Products BV
Molenvliet 22
3961 MV WIJK BIJ DUURSTEDE
The Netherlands
info@fito.nl - www.fito.eu
5. Check that the smoke detector is working and that the
battery has been activated by pressing the test button. A
beeping noise that stops of its own accord indicates that the
smoke detector has been activated and the red LED light will
flash every 10 seconds for 8-9 minutes. Testing the smoke
detector will automatically put it in reduced sensitivity
mode for 8-9 minutes.
• Never allow the detector to come into contact with fluids.
• Clean the detector regularly (once a month) using the soft
brush from a vacuum cleaner. The smoke alarm can also
be cleaned using a moist cloth.
• Repairs must be carried out by the manufacturer.
CAUTION: Never apply paint to the detector and do
not cover it in tape.
Causes of false alarm:
The smoke detector can be activated by steam, condensa-
tion, dust, smoke and small insects. These are to be preven-
ted as far as possible. See section: Never fit a smoke detec-
tor. If a detector is frequently giving a false alarm, it might be
necessary to install the detector in another location.
INSTRUCTIONS FOR REMOVAL
Do not dispose of your old detector in the
bin, but rather hand it in to a local
collection point for small, domestic waste.
LIMITATIONS OF SMOKE DETEC TORS
In countries where they are commonly in use, smoke
detectors have contributed to reducing deaths and injuries.
Independent bodies have established that they were insuf-
ficient in around 35% of fires, namely in the following
situations:
• Where the battery had been removed or was not working.
For that reason, you should test the unit regularly.
• Where smoke is not able to reach the detector in the event
of a fire, meaning the unit cannot be set off. Examples
include a fire on another floor where there is no smoke
detector, a fire behind closed doors, a fire in a chimney or
smoke being blown away from the detector. For that
reason, smoke detectors are recommended in all rooms, or
at any rate on every floor.
• Where the alarm is not heard. A person may not be woken
by the alarm if that person had consumed excess alcohol
and/or drugs.
• A few fires are not always detected on time, e.g. smoking in
bed, if there is no smoke detector in the bedroom. In the
case of escaping from gas or violent explosions,
improperly storing explosive products and flammable liquids
(petrol, paint, methylated spirit, etc.), electrical faults,
acids, children playing with matches (fire).
• The lifespan of smoke detectors is 10 years.
DECLARATION OF PERFORMANCE
You can cownload the Declaration of Performance on our
website www.fito.eu.
2015-04
FUNCTION AND MEANING OF THE LIGHT AND SOUND
SIGNALS:
Normal situation: The red LED light will flash once every 5
minutes.
Alarm: Whenever the detector detects smoke, it will emit a
loud pulsing alarm and the red LED light will flash continu-
ously until the smoke has cleared.
Low battery signal: A beeping signal every 40 seconds
means that the battery is nearly flat and the smoke detector
needs to be replaced. This signal will sound for 30 days.
When properly maintained, as described under IMPORTANT
INFORMATION, the battery and the smoke alarm should
continue to work for over a decade before reaching the end of
their lifespan. You should remove the smoke detector and
base plate from the ceiling and install a new smoke
detector.
Test and Pause Button: Your detector is fitted with a
pause button (see figure 4). This is the same button as the
test button. Press the pause/test button for 2-3 seconds.
Your smoke detector will then go into a so-called reduced
sensitivity mode for 8-9 minutes. The red LED light will flash
every 10 seconds to indicate that the silence button has
been activated. The detector will nonetheless sound the
alarm if the smoke is dense or increasing in quantity. False
Alarm: Press the test button to stop the alarm. (See Test
and Pause button)
Light sensitivity: Three short beeps every 40 seconds, means
the smoke alarm is exposed to too much light
(light spot or sun). Move the smoke detector, or remove the light
source.
Maintenance:
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fito ASD-10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fito ASD-10 in the language / languages: English as an attachment in your email.

The manual is 0.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fito ASD-10

Fito ASD-10 User Manual - German - 2 pages

Fito ASD-10 User Manual - Dutch - 1 pages

Fito ASD-10 User Manual - French - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info