648105

Fisher and Paykel QuickSmart Manual

6
Zoom out
Zoom in
Previous page
1/44
Next page
Installation instructions
4
Location
Install the machine on a solid and level floor surface ensuring it has at least 20 mm clearance on
each side. The washer must not be installed on any textured floor coverings (eg carpet, rugs).
Levelling the machine
It is IMPORTANT to level the machine to ensure good spin
performance, and to minimise noise, vibrations and wear
and tear on the washer.
1
Before positioning the machine in its final position, check
that the machine is level, front to back and side to side.
2
Manoeuvre the product into its final position (we suggest a
minimum clearance of 20 mm each side).
3
Use a spirit level to check that the machine is correctly level.
If needed, pull the machine out and wind the feet up or
down to correctly level the machine.
4
Using the spanner provided, tighten the lock nuts against
the base of the machine to lock the feet in position.
Connecting to the water supply
Inlet hoses
Important!
New hose sets provided with the washer should be used to
connect the washer to the water mains.
Old hose sets should not be re-used.
We recommend the inlet hoses are changed every 5 years.
WARNING: Failure to do so may result in a flood and
damage to property.
1
Connect the straight ends of the inlet hoses to the taps
and the elbow ends to the corresponding machine inlet
valves. The hot valve is colour coded orange to make this
easier. Make sure there are no kinks in the hoses.
2
Turn the taps on and check for leaks. Check for leaks again
after 24 hours.
Important!
The hot water temperature should not exceed 65°C and the cold water temperature not exceed35°C.
Temperatures above these may cause the machine to fault or cause damage to the machine.
Fig.3 Locking the feet
Fig.4 Inlet hose ends
Elbow
(machine) end
Straight
(tap) end
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fisher and Paykel QuickSmart at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fisher and Paykel QuickSmart in the language / languages: English as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info