671440
28
Zoom out
Zoom in
Previous page
1/32
Next page
28
Replacing the Rower Bungee Shock Cord
1. Remove the Perspex Cover from
rear of upper frame.
Disconnect sensor lead before
removing cover completely.
2. Move the Rowing Handle from the
S-Bend to a point where it is resting
on top of the tank . This helps line
up the Bungee Cord hole for easier
removal/replacement. Detach Bungee
Cord from lower rear attachment
point.
3. Unwrap the Bungee Cord from all of
the Bungee Pulleys.
Rear
Mainshaft
Bolt and
Magnetic
Ring
4. Next, remove the Magnetic Ring. To loosen
the Rear Mainshaft Bolt holding the
magnetic ring in place, it is necessary to
keep the Mainshaft and impeller assembly
from turning with the bolt. Open the yellow
tank plug, and insert a wrench wrapped in a
lint free cloth (to protect the electroplating
finish on the blades) to catch the impeller
blade and allow the Rear Mainshaft Bolt to
be loosened as shown below right with a
6mm Allen key.
Caution: Do not allow a dissimilar metal to
directly contact the impeller blade.
Premature rusting could occur . Cover any
tool inserted the tanks with a lint free
cloth and keep fingers clear.
WARNING Do not insert fingers into tank!
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Degree Vortex VX-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Degree Vortex VX-2 in the language / languages: English as an attachment in your email.

The manual is 2,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info