671440
20
Zoom out
Zoom in
Previous page
1/32
Next page
20
Assembly Instructions VX-2
STEP 6
Installing S-Bend and Frame Tensioning Bolt - VX-2
a) Carefully lower the Rower to its normal operating
position to complete assembly with S-bend
installation and Frame Tension Cable.
Install rear of S-Bend[8] onto the Upper Frame
using M10x80mm Bolt[14], M10 Nyloc Nut[17]
and 2 x M10 Washers[20].
b) Attach the S-Bend to the Footplate as shown. Tilt
the Upper Frame slightly forward to align in the
proper position.
Note: The M10x15mm S-Bend Bolt with washer is
pre-installed on the S-Bend for your convenience.
c) Align the Frame Tension Cable[4] eyelet with the
Bracket on Lower Frame and install with
M10x40mm Bolt[11], 4x M10 Plastic Washers[19]
(2 either side of eyelet and inside the Metal
Bracket) and M10 Nyloc Nut[17].
REQUIRED
Frame Tension Cable[4]
S-Bend [8]
M10x40mm Bolt [11]
M10x80mm Bolt [14]
2 x M10 Nyloc Nut [17]
4 x M10 Plastic Washers [19]
2 x M10 Washers [20]
d) Align and screw the opposite end into the Rear Leg
as shown. Tension until taut and then secure with
Retaining Nut.
c)
a)
b)
c)
d)
b)
a)
d)
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Degree Vortex VX-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Degree Vortex VX-2 in the language / languages: English as an attachment in your email.

The manual is 2,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info