737297
18
Zoom out
Zoom in
Previous page
1/24
Next page
18
Reattaching the Rower Belt
STEP 1
STEP 2
Velcro Facing Upward
Begin reattaching the Rower Belt by threading
around the Rower Belt Pulley with the Velcro side
facing upward as illustrated.
Idle Wheel
Next, thread the Belt around the Idle Wheel as
shown. Once around the Idle Wheel, attach the
Rower Belt to the Belt/Bungee Pulley. There is
an obvious “lip” at the attachment point.
Rower Handle
Belt/Bungee Pulley
STEP 3
STEP 4
STEP 5
Wind the Rower Belt onto the Belt/Bungee Pulley
until the Rower Handle is as it’s furthest forward
position.
Bungee Shock Cord
Bungee Pulley
Rethread the Bungee Shock Cord (on opposite
side of the Idle Wheel) back through the Bungee
Pulleys and tie off at the Attachment Point.
Recoil tension will decrease over time as the Bungee Shock
Cord stretches. To increase recoil tension, simply push the
Inner Clip out of the Bungee Hook from behind, pull the required
amount of bungee through the Inner Clip and replace the Inner
Clip into the Bungee Hook as shown below.
Hint: Before reattaching the Inner Clip/
Bungee Hook, tie a slip knot under slight
tension at the lower bungee pulley. This
will keep the bungee under tension while
reassembling the Bungee Hook.
Bungee Hook
Inner Clip
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Degree Viking 3 Plus 2019 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Degree Viking 3 Plus 2019 in the language / languages: English as an attachment in your email.

The manual is 1,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info