671469
18
Zoom out
Zoom in
Previous page
1/27
Next page
18
Reattaching the Rower Belt
Begin reattaching the Rower Belt by
threading around the Rower Belt Pulley
with the Velcro side facing upward as
illustrated.
Next, thread the Belt around the Idle
Wheel as shown. Once around the Idle
Wheel, attach the Rower Belt to the
Belt/Bungee Pulley. There is an obvious
“lip” at the attachment point.
Wind the Rower Belt onto the Belt/Bungee
Pulley until the Rower Handle is as it’s
furthest forward position.
If Bungee Shock Cords previous tension
seemed correct (a good way to judge is
if the Rower Handle can make it to the
furthest point forward on the top of the
Mainframe under bungee tension alone)
then simply tie off at previous position.
If the return is too slack, experiment by
tightening the tension in small increments
and testing until the correct tension is
achieved. If the Rower Handle cannot
reach the end of the seat rail during a
rowing stroke, then the Bungee Shock
Cord is over-tensioned.
Hint
Rethread the Bungee Shock Cord (on
opposite side of the Idle Wheel) back
through the Bungee Pulleys and tie off
at the Attachment Point.
Velcro Facing Upward
Idle Wheel
Bungee Shock Cord
Bungee Pulley
Rower Handle
Belt/Bungee Pulley
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Degree PACIFIC AR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Degree PACIFIC AR in the language / languages: English as an attachment in your email.

The manual is 2,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info