Seat Indentation
Left/Right Side Rails
Rower Seat
STEP 3
Install the Mainframe[1] onto the Side Rail Assembly[2] as shown.
You will need 8x M8x45mm Bolts[11], 16x M8 Washers[7], 8x M8
Standard Nuts[8] and 8x M8 Nyloc Nuts[9].
Secure the front Lower Bracket first, then the Footboard but
DO NOT TIGHTEN. You may find that the Lower Bracket Bolts can
be difficult to access. You can tighten these bolts completely once
the Rower is standing in the vertical position so for the moment,
simply align and loosely thread lower bolts/nuts.
REQUIRED
Mainframe [1]
Side Rails Assembly [2]
16x M8 Washers [7]
8x M8 Standard Nuts [8]
8x Nyloc Nuts [9]
8x M8 x 45mm Bolts [11]
Bolt Assembly Close Up
M8 Standard Nut
M8x45mm Bolt
M8 Washer
M8 Nyloc Nut
CAUTION
Nyloc nuts must be
outside the standard nut
and washer to properly
secure assembly.
Note: Clean wheels and
tracks weekly with a soft
dry cloth in order to
decrease the rate of wear
on both wheels and track.
Nyloc
Nuts
Nyloc Nuts must be
outside the standard nut
and washer to properly
secure assembly.
Nyloc
Nuts