785015
4
Zoom out
Zoom in
Previous page
1/7
Next page
E-3
Remove the battery insulator tabs by pulling them out of the battery
compartments on the transmitter and receivers before first use.
Note : Remove and reinstall the batteries if there is no response after pulling out
the insulation tab.
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to
death.
Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the
body, seek immediate medical attention.
BATTERY WARNING
1. Be sure that the batteries are installed correctly. Wrong polarity may damage
the unit
2. Use only the size and type of batteries specified.
3. Do not mix old and new batteries.
4. If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and may
void the warranty.
5. Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacturer’s directions)
6. Do not dispose of batteries in fire, batteries may leak or explode.
PAIRING THE TRANSMITTER WITH THE RECEIVERS
1. The transmitter will automatically turn ON when you remove the battery
insulator tab from the battery compartment on the transmitter.
2. Remove the battery insulator tabs from the receivers.
3. Slide the receiver ON/OFF SWITCH (#5) to the ON position.
4. The LED INDICATOR (#3) on the receiver will flash and a beeping sound will
start. The receiver is now ready for pairing with the transmitter.
5. Press the COLOR CODED BUTTON (#2) on the transmitter that matches the
COLOR CODED MARKING (#4) on the receiver that is beeping.
6. The beep sound will stop and the transmitter is now paired with that receiver.
7. Repeat steps 3 to 6 to pair the other 3 receivers.
Note :
Make sure the transmitter and receiver are close to each other when pairing.
If the pairing fails, the beep sound will continue and will not stop.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Alert SFA200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Alert SFA200 in the language / languages: English as an attachment in your email.

The manual is 0.61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info