795135
3
Zoom out
Zoom in
Previous page
1/5
Next page
34
InItIAl SetuP
EMERGENCY OVERRIDE KEY USE
Insert emergency override key into
the lock, turn it counterclockwise
and pull the door open.
BATTERY INSTALL
1 Remove battery cover.
2 Install four (4) AA batteries. Make sure to
install them facing the proper direction.
3 Replace the battery cover.
4 When installed correctly, a yellow light
will ash on the digital keypad.
ProgrAmmIng A PerSonAl PASScode
1 Open the safe door.
2 Press the reset button located on the left side of the
battery compartment. (The lock will beep two times
and the yellow light will blink two times).
3 Enter your new three to eight (3-8) digit passcode
followed by ‘A’ or ‘B. (The lock will beep two times and
the yellow light will blink two times).
NOTE: After pressing the reset button, your passcode must
be programmed within 10 seconds, or it will not be accepted.
LOCKOUT PENALTY:
Green light means correct passcode has been entered. Rapid beeping yellow light
means incorrect passcode has been entered. Entering incorrect passcode three (3)
times will result in lock-out.
IF LOCK-OUT OCCURS:
1 Wait 15 minutes before entering your (3-8) digit passcode.
2 Check to see if the batteries have been installed properly and replace if
necessary.
3 Contact Consumer Aairs at 1-800-323-9005.
3
2
1
6
5
4
9
8
7
B
0
A
Initial Setup Shelf and Mounting
FORGOTTEN PASSCODE
1 Insert override key, turn counterclockwise and pull the door open.
2 Follow instructions on Pg. 3 ‘PROGRAMMING A PERSONAL PASSCODE’ to reset
your passcode.
OPENING SAFE
1 Insert knob key.
2 Enter your three to eight (3-8) digit passcode
followed by ‘A’ or ‘B.
3 Turn the key clockwise and pull the door open.
CLOSING SAFE
1 Push door closed.
2 Turn knob key counterclockwise fully into locked position.
ImPortAnt Turn the light switch o before closing the safe. Leaving the
light switch on will result in loss of battery power.
ShelF And mountIng
INSTALLING THE SHELF 2072F ONLY
Slide shelf into place on top of shelf racks.
MOUNTING INSTRUCTIONS
1 Remove rubber feet and mounting screws
from safe with Phillip’s head screwdriver.
2 Place your safe where you want it to be mounted. Safe weighs
(36.1 lbs - 2072F; 19.8 lbs. – 2073F; 13.2 lbs. – 2025F) when empty so
be sure that if you’re mounting on a shelf that it will support the weight.
3 Open your safe.
4 Remove the bottom carpet and nd the screw holes.
Mark the safe’s placement through the holes with a pencil.
5 Drill holes in the shelf.
6 Place screws through holes in shelf and rubber feet.
7 Place safe on shelf over the screws and rubber feet. Use a socket wrench
to tighten safe into place.
3
2
1
6
5
4
9
8
7
B
0
A
AA
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
3
2
1
6
5
4
9
8
7
B
0
A
Beep
3
2
1
6
5
4
9
8
7
B
0
A
Beep
AA
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA +
AA
+-
AA
+-
AA
+-
AA
+-
3
2
1
6
5
4
9
8
7
B
0
A
3
2
1
6
5
4
9
8
7
B
0
A
1
2
3 4
AA +
AA
+-
AA
+-
AA
+-
AA
+-
15
6
7
4
4
1
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for First Alert 2072F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of First Alert 2072F in the language / languages: English as an attachment in your email.

The manual is 3.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info