737931
20
Zoom out
Zoom in
Previous page
1/32
Next page
19
5.5.2.4.1 Pulsprogramma IND
LET OP: Voor dit programma moet een borstgordel worden
gebruikt!
Bij het pulsprogramma IND kunt u uw eigen pulswaarde
instellen. De computer past de weerstand aan op basis van uw
hartslag, zodat u altijd 3-5 slagen rond uw limiet traint.
Druk op IND om te starten en bevestig met ENTER.
USER 0 wordt weergegeven. Met de pijltjestoetsen kunt u de
user selecteren en met ENTER bevestigen.
Nu verschijnt TIME”. Met de pijltjestoetsen kunt u de gewenste
trainingstijd (in minuten) invoeren. De tijd hoeft u niet in te
voeren. Door te trappen begint uw training.
Druk op ENTER om de afstand in te voeren die u wilt afleggen.
Met de pijltjestoetsen kunt u de waarde aanpassen en met ENTER
bevestigen. Om de training te starten, begint u te trappen.
Daarna wordt gevraagd hoeveel calorieën u wilt verbranden. Met
de pijltjestoetsen kunt u de waarde aanpassen en met ENTER
bevestigen. Om de training te starten, begint u te trappen.
Voor tijd, afstand en calorieënverbruik wordt slechts één waarde
opgeslagen. Als u bijvoorbeeld een tijd invoert en vervolgens de
afstand, wordt de tijd op nul gezet.
Er wordt naar het start-wattvermogen gevraagd. Met de
pijltjestoetsen kunt u de waarde aanpassen en met ENTER
bevestigen.
Er wordt naar de maximale trainingspuls gevraagd. Er zijn twee
opties:
1) Alleen bovengrens: De weerstand wordt zo geregeld, dat de
trainingspuls rond de maximale puls ligt.
2) Bij de invoer van een onder- en bovengrens, wordt de
weerstand zo lang verhoogd tot uw trainingspuls boven de
bovengrens komt. Daarna wordt deze zo lang verlaagd tot uw
trainingspuls onder de onderste pulsgrens ligt.
Door te trappen begint uw training.
Na de training heeft u de mogelijkheid de trainingsgegevens op
te slaan. Selecteer daarvoor met de pijltjestoetsen YES”. Indien
u de gegevens niet wilt opslaan, selecteert u “NO”.
5.5.2.5 RECOVERY
Druk bij het einde van de training op “RECOVERY” en stop met
trappen. De computer meet gedurende 60 seconden uw puls.
Bij een pulsverschil van ca. 20% krijgt u het cijfer F1 (zeer goed).
5.5.2.4.1 Heart rate program IND
Note: You must wear the heart rate transmitter strap for these
programs
.
The program IND allows you to set your own target heart rate.
After selecting your heart rate target the program will attempt
to keep you at or within 3-5 heart beats per minute of this value.
Press the IND, then press the Enter key.
The display shows USER 0, by pressing the arrow-keys you can
choose your user and confirm by pressing ENTER.
Next is Time. You may adjust the Time with arrow-keys and
press Enter to continue. It is not a must to set the the time.
Start pedalling and your excercise beginns.
Press ENTER, and set the distance, which you want to finish
with the arrow-keys. It is not a must to set the distance. Start
pedalling and your excercise beginns.
Now you insert the calorie value by pressing the arrow-keys and
conrm the value, by pressing ENTER or start pedalling to start
your exercise.
For Time, Distance or Calories, you are able to set only one of
these. If you try to set a second value, the first one will be reset.
Now you can set the starting Watt value. With arrow-keys, the
value can be set, press Enter to continue.
Now you can set the max trainings heartrate. There are two
options:
1) Set only max limit. The resistance will be controlled, that your
exercise heartrate will be around the max set limit.
2) Setting of min and max limit. the resistance will be increased,
till your exercise heartrate is over the max set target. After that,
the resistance will be decreased till your exercise heartrate is
lower than the min set value. So there is a range, in which the
resistance will be changed according to your heartrate range.
Start pedalling and you training start
After you finished your exercise, you can save the exercise data
by selecting „yes“ with the arrow-keys, if not select „NO“ and
press ENTER.
5.5.2.5 RECOVERY
After you nished your exercise press RECOVERY and stop
pedalling. The computer will measure the heartrate for the next
60 seconds. If the dierence between the starting and end
heartrate is around 20%, you will get the grade F1 (very good).
Heruntergeladen von manualslib.de Handbücher-Suchmachiene
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Finnlo 3286 Loxon XTR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Finnlo 3286 Loxon XTR in the language / languages: German as an attachment in your email.

The manual is 2,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Finnlo 3286 Loxon XTR

Finnlo 3286 Loxon XTR User Manual - English - 32 pages

Finnlo 3286 Loxon XTR User Manual - Dutch - 23 pages

Finnlo 3286 Loxon XTR User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info