528538

Finnlo 3278 LOXON XT Manual

27
Zoom out
Zoom in
Previous page
1/48
Next page
You can set a DRINK FIT function during the setting of your personal datas. You can choose between OFF, 15, 20,
25 and 30minutes. The symbol will be shown for 3 seconds with an beep in the matrix, it doesn´t matter in which
program you are.

%XPLANATIONOFTHESYMBOLSANDNEEDTOKNOW
The symbol demand you to begin to pedal. the set values will be confirmed and you start your
!0EDALLING
"$RINK&)4
$3ETTINGVALUES
Target values: After achieving the target values, there will be a beep and the computer will stop counting. The monitor will show the
average and trip values. To continue your exercise, you have to reactivate the computer by pressing the DELETE button.
!TTENTION Except the heartrate value, you can set only one further value. If you set another value, the already set value will be set to
OFF. To start your exercise, beginn to pedal, after you have set the target value.
%()7ATT
In PROGRAM-Mode, you can set the max Watt resistance which will be reached during your exercise. All other Watt values will be
calculatated accordingly to the max value.
&2ECOVERY
After you finished your exercise press RECOVERY and stop pedalling. The computer will measure the heartrate for the next 60 seconds.
If the difference between the starting and end heartrate is around 20%, you will get the grade F1 (very good).
#7AKINGUPTHECOMPUTERFROMTHESNOOZEMODE
To reactivate the computer from the snooze mode, press any button, please. A pedalling has no function in this mode.
')NCREASINGOFTHE7ATTVALUEDURING(2#-ODE
The resistance (watt value) will be increase every 30 seconds for 10 Watt, till you reach a heart rate value, which is 5 beats lower than
your target. The resistance will stay at this level for 1 minute. If there is no further heartrate change, the resistance will increase again.
If the actual heartrate is for 5 seconds higher than your target, the resistance will decrease immediately for 20 Watt and than every 20
seconds for 10 Watt, till your actual heartrate is lower than the target. If it is lower than the target heartrate, the resistance will increase
again.
For IND: You can set a heartrate zone. The increasing is following the same procedure like above mentioned. Pay attention, that if your
actual heartrate cannot be under the LO limit, the resistance will not increase anymore. You have to stop your exercise and set new
targets!
The arrows in the heartrate windows indicate, that the resistance cannot be increased or decreased and so you have to pedal slower
(arrow down) or pedal faster (arrow up).
If your actual heartrate is five beats lower than the set target, the circle between the two arrows start to blink. It indicates, that you
are reaching your target value. If your actual heartrate is higher than the high limit, there will be a beep and the actual heartrate starts
blinking.
&!'%
Needed for max heartrate calculation.
'+CALCALCULATION
Shows the energy consumption, based on a efficiency of 22% to provide the mechanical power. Conversion Joule into Kcal:
1cal=4,1867J.
Example: 60Watt for 20minutes
60(Watt) x 20(Min) x 60Rpm=72000J= 17197cal.
17197cal is equal to a efficieny of 22%. Totally the calorie consumption is 78169cal oder 78Kcal.
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Finnlo 3278 LOXON XT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Finnlo 3278 LOXON XT in the language / languages: English, German as an attachment in your email.

The manual is 2,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info