528516
26
Zoom out
Zoom in
Previous page
1/44
Next page
5.2.2 Explanation of the symbols and need to know
The symbol demands you to begin to pedal. The set values will be confirmed and you can start your exercise.
A) Pedalling
C) Setting values
Target values: After achieving the target values, there will be a beep and the computer will stop counting. The monitor will show the
average and trip values. To continue your exercise, you have to reactivate the computer by pressing the DELETE button.
Attention: Except the heartrate value, you can set only one further value. If you set another value, the already set value will be set to OFF.
To start your exercise, beginn to pedal, after you have set the target value.
D) Recovery
After you finished your exercise press RECOVERY and stop pedalling. The computer will measure the heartrate for the next 60 seconds. If
the difference between the starting and end heartrate is around 20%, you will get the grade F1 (very good).
E) Increasing of the Watt value during HRC -Mode
The resistance (watt value) will be increase every 30 seconds for 10 Watt, till you reach a heart rate value, which is 5 beats lower than your
target. The resistance will stay at this level for 1 minute. If there is no further heartrate change, the resistance will increase again. If the
actual heartrate is for 5 seconds higher than your target, the resistance will decrease immediately for 20 Watt and than every 20 seconds
for 10 Watt, till your actual heartrate is lower than the target. If it is lower than the target heartrate, the resistance will increase again.
For IND: You can set a heartrate zone. The increasing is following the same procedure like above mentioned. Pay attention, that if your
actual heartrate cannot be under the LO limit, the resistance will not increase anymore. You have to stop your exercise and set new targets!
The arrows in the heartrate windows indicate, that the resistance cannot be increased or decreased and so you have to pedal slower (arrow
down) or pedal faster (arrow up).
If your actual heartrate is five beats lower than the set target, the circle between the two arrows start to blink. It indicates, that you are
reaching your target. If your actual heartrate is higher than the high limit, there will be a beep and the actual heartrate is blinking.
Please use for the correct working of the HRC-Mode a chestbelt.
B) Waking up the computer from the snooze mode
To reactivate the computer from the snooze mode, press any button. A pedalling has no function in this mode.
F) AGE
Needed for max heartrate calculation.
G) Kcal calculation
Shows the energy consumption, based on a efficiency of 22% to provide the mechanical power. Conversion Joule into Kcal: 1cal=4,1867J.
Example: 60 Watt for 20minutes
60 (Watt) x 20 (Min) x 60 Rpm = 72000J = 17197cal.
17197cal is equal to a efficieny of 22%. Totally the calories consumption is 78169cal or 78Kcal.
25
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Finnlo 3170 Exum at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Finnlo 3170 Exum in the language / languages: English, Dutch as an attachment in your email.

The manual is 18,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Finnlo 3170 Exum

Finnlo 3170 Exum User Manual - English, German - 45 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info