737932
27
Zoom out
Zoom in
Previous page
1/45
Next page
LEVEL
Shows the resistance in 16 levels in the rpm-dependant exercise. Additional the profile of the programs, will be shown, too.
5.2.1 Remarks on the individual functions
A) End or break of your exercise
For less than 15rpm/min the computer will recognice an end or break. It will show alternativly the average data for rpm, speed, watt
and the heartrate. The display shows the average sign. After that TRIP will be shown in the display and the values for distance, time and
kcal. The datas can be seen for 4 minutes. After 4 minutes, the computer will go into snooze mode. You can wake him up by pressing
any button.
B) Pulsemeasurement
Pulse measurement with the chest strap: The computer is equipped with a chip, which makes wireless pulse transmission possible
using a chest strap (5.0 – 5.5 kHz).
Handpulse measurement: Plug in the hand pulse cable in the hand pulse plug (Pulse input) at the back of the computer. Please put both
hands on the sensors, which are assembled on the handlebar. If you lift off one hand off the sensor during measuring, it will take some
time to reach the correct watt value. Both hands have to be kept on the hand pulse sensors.
For a heartrate controlled exercise, please use the chestbelt, which can be bought at the Finnlo Service.
WARNING: Systems with heartrate control can be incorrect. To much exercise could injure your body or can cause
dead. If you feel light theaded or weak, stop your exercise immediately!
5.2.2 Explanation of the symbols and need to know
The symbol demand you to begin to pedal. the set values will be confirmed and you start your exercise.
A) Pedalling
C) Setting values
Target values: After achieving the target values, there will be a beep and the computer will stop counting. The monitor will show the
average and trip values. To continue your exercise, you have to reactivate the computer by pressing the DELETE button.
Attention: Except the heartrate value, you can set only one further value. If you set another value, the already set value will be set to
OFF. To start your exercise, beginn to pedal, after you have set the target value.
D) Recovery
After you finished your exercise press RECOVERY and stop pedalling. The computer will measure the heartrate for the next 60 seconds.
If the difference between the starting and end heartrate is around 20%, you will get the grade F1 (very good).
E) Increasing of the Watt value during HRC -Mode
The resistance (watt value) will be increase every 30 seconds for 10 Watt, till you reach a heart rate value, which is 5 beats lower than
your target. The resistance will stay at this level for 1 minute. If there is no further heartrate change, the resistance will increase again.
If the actual heartrate is for 5 seconds higher than your target, the resistance will decrease immediately for 20 Watt and than every 20
seconds for 10 Watt, till your actual heartrate is lower than the target. If it is lower than the target heartrate, the resistance will increase
again.
For IND: You can set an individual max heartrate.
B) Waking up the computer from the snooze mode
To reactivate the computer from the snooze mode, press any button, please. A pedalling has no function in this mode.
26
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Finnlo 3157 EXUM III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Finnlo 3157 EXUM III in the language / languages: English, German as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Finnlo 3157 EXUM III

Finnlo 3157 EXUM III User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info