Manual Festool T 12en3 (page 17 of 97) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

497588

Zoom out

Zoom in

1/97

T 12+3, T 15+3, T 18+3

The LED lamp [1-5] lights up when the on/off

switch [1-3] is pressed and lights up the

working area.

9.2 Bit store [1-2]

Bits or bit holders are inserted sideways into

the bit store.

9.3 Acoustic warning signal

Acoustic warning signals sound and the ma-

chine switches off in the following operating

states:

10 Service and maintenance

Observe the following instructions:

– Keep the air slits on the machine and the

charger free and clean to ensure adequate

cooling.

– Keep the contacts on the machine, charger

and battery pack clean.

Information on battery packs

– Where possible, store the battery pack in a

cool, dry place at a temperature between

5 °C and 25 °C.

– Battery packs are most efficient at temper-

atures between 20 °C and 30 °C.

– Protect the battery pack from moisture,

water and heat.

– Significantly shorter operating times after

each charge indicate that the battery pack

is worn and should be replaced with a new

one.

– The LiIon battery pack is fully compatible

with the charger! Integrated electronics

prevent overloading and overheating dur-

ing the charging process.

– Do not leave flat battery packs in a charger

disconnected from the mains power supply

for longer than one month. There is a risk

of total discharge and the maximum power

of the battery pack may decrease.

– Store the battery pack in its packaging to

reduce the risk of short circuits..

– If LiIon battery packs are to be stored for

long periods without use, they should be

charged to 40 % capacity (approx.

15 mins. charging period).

11 Accessories

Use only original Festool accessories and

Festool consumable material intended for

this machine because these components are

designed specifically for the machine. Using

accessories and consumable material from

other suppliers will most likely affect the

quality of your working results and limit any

warranty claims. Machine wear or your own

personal workload may increase depending

on the application. Protect yourself and your

machine, and preserve your warranty claims

by always using original Festool accessories

and Festool consumable material!

The order numbers of the accessories and

tools can be found in the Festool catalogue or

on the Internet under "www.festool.com".

12 Disposal

Do not throw the power tool in your house-

hold waste! Dispose of machines, accesso-

ries and packaging at an environmentally re-

sponsible recycling centre. Observe the valid

national regulations.

EU only:

European Directive 2002/96/EC

stipulates that used electric power tools must

be collected separately and disposed of at an

environmentally responsible recycling cen-

tre.

Return used or faulty battery packs to your

local specialist retailer, Festool after-sales

service or a designated public waste man-

agement facility. The battery packs will then

be recycled. (Observe the regulations appli-

cable in your country). The batteries must be

discharged on return.

EU only:

European Directive 91/157/EEC

stipulates that faulty or used battery packs/

batteries must be recycled.

13 Transport

The equivalent amount of lithium in the LiIon

battery pack is less than the applicable limit

value and certified as per UN manual ST/SG/

AC.10/11/rev. 3 part III, subsection 38.3.

The LiIon battery pack is therefore not sub-

Battery flat or machine

overloaded.

– Change the battery.

– Place the machine under re-

duced stres.

Machine is overheating.

– You must allow the machine

to cool before using again.

LiIon battery pack is faulty

or has overheated.

– Once the battery pack has

cooled, perform a functional

check using the charger.

peep

― ―

peep peep

―

peep peep peep

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Festool T 12en3 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Festool T 12en3 Manual

Product: