Manual Festool CTM 22 E (page 15 of 78) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

574994

Zoom out

Zoom in

1/78

4.4 Emptying the dirt trap (2.10)

Always remove the upper part of the

vacuum cleaner before emptying the dirt

container!

- Open the vacuum cleaner,

- Raise the upper part slightly, depress the

support (2.5),

- Raise the upper part to the stop (vertical

position),

- Remove the upper part by moving it for-

wards horizontally,

- Empty the dirt container,

- Replace the upper part. Warning: Make

sure that both upper-part pins are fully

inserted in the recesses (1.5)!

- Close the vacuum cleaner.

4.5 Stand/Brake

The wheels can be blocked by the brakes

(2.8), thus preventing the vacuum cleaner

from rolling away unexpectedly.

4.6 Hose depot (partly in scope of

delivery)

Securing the hose depot on the dust extrac-

tor: see Fig. 4. When work is complete, you

can guide the extractor hose through the

opening (4.1) and deposit the hose in the

depot. Similarly, the mains cable can also

be guided through the opening (4.2) and

deposited in the hose depot.

5 Application

- A systainer can be ﬁ xed to the storage

area (1.12) with the two clamps (1.10).

Tools or accessories can also be stowed

on the storage area and in the storage

compartments (1.6, not with CTM 22).

- A hose coupling (1.11) (487072) can be

plugged into the opening (1.8). The suc-

tion hose is connected to the tool from

above with the hose coupling. Alterna-

tively, a hose clip (452998) can be ﬁ tted

for coiling the suction hose.

- The push handle (2.11) (452921; supplied

ready with CTM 44 and CTM 55) makes the

vacuum cleaner easier to move. Acces-

sories (e.g. vacuum accessories) can be

ﬁ xed to the push handle batten (2.9).

- An air blast is obtained by inserting a suc-

tion hose in the blast opening (2.7).

5.1 Vacuuming dry materials

A ﬁ lter bag must be used without

exception when evacuating noxious

substances!

Before using the vacuum cleaner to evacu-

ate dry substances, a ﬁ lter bag must always

be inserted in the container.

Then the evacuated material can be dis-

posed of easily. The ﬁ lter element becomes

damp after evacuating liquids. A damp ﬁ lter

element suffers more wear and tear if it

is used for dry materials. Accordingly, the

ﬁ lter element should be dried or replaced

with a dry one before dry operation.

5.2 Vacuuming liquids

Do not evacuate combustible liquids!

If foam or liquid escapes, stop work

immediately and empty the dirt con-

tainer.

The ﬁ lter bag has to be removed before

evacuating liquids. We recommend use of a

special wet ﬁ lter. When the maximum ﬁ lling

level is reached, a bag-full indicator (2.12)

automatically interrupts extraction.

5.3 Volume ﬂ ow monitoring

If the air speed in the suction hose drops

below 20 m/s, an acoustic warning signal

sounds for safety reasons.

Possible causes and adjustments

Cause

- Adjustment

Suction force regulator (1.4) set to a

too low value

- Adjust suction force regulator to a higher

value

Rotary knob (1.2) not adjusted to the

connected hose diameter

- Adjust to correct hose diameter

Suction hose blocked or twisted

- Remove blockage or twist

Filter bag full

- Change ﬁ lter bag

Filter element dirty

- Change ﬁ lter element

- Only when operating without a ﬁ lter bag:

clean ﬁ lter element

Electronic monitoring system malfunc-

tioning

- Call Festool customer service for adjust-

ment

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Festool CTM 22 E in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,66 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Festool CTM 22 E Manual

Product: