724580
14
Zoom out
Zoom in
Previous page
1/32
Next page
Air Brush Kit
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. TAC23 • 05/2020 • 800493
(toll free)
12
Getting Started – Air Compressor
NOTE: Before operating, make sure the Air Compressor is: in a well
ventilated area; on a level surface; well away from ammable objects.
Never paint in an area without proper ventilation or near potential ignition
sources.
1. The ttings on each end of the air hose (11) are the same. Connect one of
these ttings to the M5 x 0.5mm male side of the Connector (1/8” female /
M5 x 0.5mm male) (6), align the threads and tighten the tting in a clockwise
direction nger tight till rm (Fig A1). Then Connect 1/8” female side
to the 1/8” pitch thread air hose air outlet tting/ connection (hose to
compressor) (9), align the threads and tighten the tting in a clockwise
direction nger tight till rm (Fig A2)
2. Connect the remaining tting on the air hose (11) to the air brush inlet
tting (22). Align the thread and screw in a clockwise direction nger
tight until rm (Fig B).
3. Make sure the on/o switch (1) is in the OFF position as indicated by an
“O” on the on/o switch (Fig C).
4. Plug the power cord (3) into a mains socket (Fig D).
5. Turn the on/o switch (1) on the compressor to the ON position as
indicated by an “I” on the on/o switch (Fig E).
NOTE: The compressor automatically runs when the pressure at the
pressure switch falls below 43.5 PSI.
When the pressure at the pressure switch reaches 57 PSI the compressor
will stop.
6. The outlet pressure is controlled by the air outlet regulator (27) which can
be adjusted up or down, from zero PSI to Max 57 PSI, depending on the
operator’s requirement. The pressure gauge is an indication of the outlet
pressure, and should be read with air owing through the air brush to
indicate a true reading (Fig F).
Operation
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex TAC23 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex TAC23 in the language / languages: English as an attachment in your email.

The manual is 5,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info