724593
34
Zoom out
Zoom in
Previous page
1/44
Next page
52cc 2 Stroke Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. SBC52 • 02/2020 • 700710
(toll free)
32
Adjusting the speed on the Brushcutter / Line Trimmer
NOTE: The cutting head (spool and line) will not rotate at the idle speed.
The cutting head (spool and line) will engage and
rotate when the speed of the motor is increased.
1. To increase speed and engage the cutting head,
squeeze the safety lever (9) and then throttle trig-
ger (8). (Fig. AP)
2. To decrease the speed, slowly release the throttle
trigger (8) to the desired speed.
3. To disengage the cutter head (spool and line),
release all pressure on the throttle trigger (8) and
allow the motor to return to idle. The cutter head
(spool and line) will disengage at idle.
NOTE: Be aware that when using the 3T brushcutter blade (28), it will take a
few seconds to run down.
IMPORTANT: If the cutting head (spool and line) does not disengage and
stop when the throttle is in the idle position, TURN OFF the petrol motor and
have the unit checked at a service centre. This should be checked EVERY time
the motor is started.
Stopping the Brushcutter/ Line Trimmer
1. Release the throttle trigger (8) and allow the engine to idle for a few mo-
ments.
2. Slide the on/o switch (10) to the ‘OFF’ position (towards to the lower
shaft) as marked with “STOP” and a directional arrow. Also indicated on
the side of the handle housing by an “O”.
3. The engine will now stop.
Running in the engine
1. During the rst 2–3 hours of work, run the engine at a moderate RPM.
2. We advise you in any case not to maintain your engine at a high speed as
the dierent components must settle with each other during the process of
running in the engine.
3. It is at the end of the running in period that the engine will reach its maxi-
A P.
O
-
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex SBC52 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex SBC52 in the language / languages: English as an attachment in your email.

The manual is 6,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info