724583
15
Zoom out
Zoom in
Previous page
1/19
Next page
AFTER SALES SUPPORT
(toll free)MODEL No.: PCT161 • 05/2020 • 701261
e-mail: info.aldi@positecgroup.com
AUS
12
1300 889 028
AUS
45W Staple / Nail Gun
We suggest you take it in a sealed container to your local service station for
reclamation. Do not throw it in the trash or pour it into the earth.
What your 3 year warranty means
Great care has gone into the manufacture of this product and it should
therefore provide you with years of good service when used properly.
In the event of product failure within its intended use over the course of the
rst 3 years after the date of purchase, we will remedy the problem as quickly
as possible once it has been brought to our attention. In the unlikely event
of such an occurrence, or if you require any information about the product
please contact us via our after sales support services, details of which can be
found in this manual and on the product itself.
After Sales Support TEL: 1300 889 028 or email: info.aldi@positecgroup.com
Fault Cause Remedy
1. Product
does not start
1.1 Not connected to
power supply
1.2 Product not switched on.
1.3 Power cord or plug is
defective
1.4 Other electrical defect
to the product
1.1 Connect to power
supply
1.2 Press down the “I” on
the on/o switch (6).
1.3 Contact customer service
1.4 Contact customer service
2. Product
does not
reach full
power
2.1 Extension cord not
suitable for operation with
the product
2.2 Power source has too
low voltage
2.1 Use a proper extension
cord
2.2 Connect to another
power source
3. Nails (10)
/ staples (9)
jam in tool
3.1 Wrong size nails(10) /
staples (9)
3.2 Driver channel worn
3.3 Bent nails (10) / staples (9)
3.4 Loose magazine/nose screws
3.5 Broken/chipped driver
3.1 Use only recommended
nails (10) / staples (9) sizes
3.2 Replace nail / staple
3.3 Discontinue using
these nails (10) / staples (9)
3.4 Tighten all screws
3.5 Replace nail / staple
For other issues not covered in this chart, please call Customer Service on 1300 889 028.
FAQ/Troubleshooting
15


Need help? Post your question in this forum.

Forumrules
1

Forum

ferrex-pct161

Reset search

  • Where do you buy replace staples I been to all hardware store and they don’t have them email on onya.388@gmail.com thank lyndon Submitted on 21-5-2022 at 07:57

    Reply Report abuse
  • Can I buy nails for the Ferrex 45 W staple gun (701261) from Bunnings or do they have to be supplied by Ferrex? Submitted on 14-9-2021 at 07:01

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex PCT161 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex PCT161 in the language / languages: English as an attachment in your email.

The manual is 1,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info