724603
26
Zoom out
Zoom in
Previous page
1/42
Next page
4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. DM46P-DO160 • 09/2018 • 60751
(toll free)
24
info.aldi@positecgroup.com
1300 889 028
10/2019 10852
Preparation
Adding and checking the oil
IMPORTANT: The motor of this mower is packed with NO OIL in the motor.
Prior to starting the motor, Oil MUST be added to the sump of the motor.
Failure to add sucient oil will result in damage to the motor which is NOT
covered under the warranty of the mower.
On a new mower, the motor needs to be lled with 350ml of SAE 10W/30
engine oil.
Each time the mower is used, the oil level should be checked and if low, add
sucient oil to ensure the oil level is to the full mark on the oil dipstick (17).
1. Position the lawn mower on a at and level surface. Clean the area directly
around the oil ller cap (17).
2. Remove the oil ller cap (17) by unscrewing it in an anti-clockwise
direction, and lift the cap outwards (Fig M).
Clean the oil dipstick (17) with a clean cloth, cleaning away any visual oil.
NOTE: The cap is a full threaded t.
3. FOR A NEW MOWER, add 350ml of SAE 10W/30 engine oil. Before replacing
the dip stick / ller cap, allow a minute or so to allow the oil in the ller tube
to fully drain of oil.
4. For both a new mower and also a previously used mower, measure the
amount of oil in the motor by re-inserting the oil dipstick back on top of
the ller tube, BUT DO NOT screw the cap in place.
5. After a few seconds, remove and inspect the oil level on the bottom of the
oil dipstick (17). (Fig N)
6. The oil level should be between the low and maximum marked section of
the oil dipstick (17) (Fig O). If the oil level is sucient replace the oil cap by
inserting and screwing back in the oil ller tube in a clockwise direction
until rm.
7. If the oil level is insucient, i.e. the oil level is not on the marked section of
the oil dipstick (17), add further oil in 50ml intervals and repeat steps 4, 5, 6,
and 7 until the correct oil level is obtained.
Always ensure the oil ller cap (17) is rmly locked in place before the
motor is started. Do not over ll with oil above the maximum mark.
Only use SAE 10W/30 engine oil.
Preparation
N.
O.
HIGH
LOW
CORRECT
LEVEL
M.
TIGHTEN
LOOSEN
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferrex DM46P-DO160 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferrex DM46P-DO160 in the language / languages: English as an attachment in your email.

The manual is 6,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info