632724
5
Zoom out
Zoom in
Previous page
1/22
Next page
HEAD ADJUSTMENTS
Fig. 3
The head of the trimmer can be adjusted up or down.
This allows comfortable cutting at a variety of angles.
Grip the head of the trimmer and press and hold the
button on the side.
Adjust the head to the desired angle.
Release the button to lock the head in the selected
position.
EXTENSION TUBE ADJUSTMENT
Fig. 4
The handle length on this product can be varied, allowing
you to reach difficult places without the use of a ladder.
Grip the head of the product firmly; lift the lever on
the upper handle.
Press the lever firmly down to lock the handle
Important: Do not charge your battery in a very cold
room (below 5ºC) or above 40 ºC (104F).
4. USE
CARRYING THE BATTERY PACK
Wear the carrying belt with battery pack across your
chest to ensure it does not swing around.
STARTING AND STOPPING
Fig. 1
The handle is designed with an unlock button to prevent
accidental starting.
Remove the blade guard (6)
Press and hold the unlock button (3) located on
either side of the handle, then squeeze the main
switch (2)
Release the main switch to stop the blades.
Wait for it to stop before releasing your grip on the
handle or putting your hand near the cutting area.
USING THE BATTERY CHARGER
Fig. 2
The battery has to be disconnected from the machine to
charge it.
Rotate the metal retaining ring counter clockwise
Pull the socket from the battery
Connect the battery charger correctly to the socket
on the battery (see the notch in the plug) and plug the
charger into the mains.
The battery needs a full 12 hours to charge fully from
flat.
The battery will not be damaged if left on charge over
12 hours.
Before first use charge the battery for 16 hours
Never store the product with a flat battery
TRIMMING A HEDGE - BEST METHOD
Ideally a hedge should be wider at the bottom than
the top. This will improve light penetration, keeping
the hedge healthy. If possible, trim both sides of the
hedge.
When trimming the sides of the hedge, trim from the
bottom upwards. This will ensure there are no hedge
trimmings obscuring or interfering with your cut
strokes.
The blade should not be forced to cut too deep. Cut
lightly through the surface of the hedge.
When trimming the top of the hedge, trim away from
you but do not over-reach. It is much wiser and safer
to move along and cut within your reach remaining
on two feet at all times.
Warning: Do not let the blade come into contact with
wire meshing or fencing material. It could damage the
material and your trimmer.
STORAGE
When storing the machine for longer than 6 weeks:
Fully discharge the battery (by running the product)
and then recharge the battery for 12 hours.
Store in a dry and frost-free place.
Recharge the battery every 1 or 2 months during the
winter, because the battery will discharge slowly.
5. SERVICE & MAINTENANCE
CLEANING
To reduce the risk of electric shock the charger must be
unplugged from the power supply and the battery
removed before cleaning (or maintaining) the charger.
LUBRICATION
The machine requires no additional lubrication.
ENVIRONMENT
You battery contains materials that are considered
toxic. Dispose of the battery through an
environmentally safe waste disposal centre.
FAULTS
Should you experience any problems at all with this
product or require spare parts, ring your nearest
authorised dealer.
Ferm 5
Grip om klipperens hoved, tryk og hold knappen
nede på siden.
Indstil hovedet til den ønskede vinkel
Frigør knappen for at låse hovedet i den valgte
position.
FORLÆNGERRØRSJUSTERING
Fig. 4
Håndlængden på dette produkt kan justeres, hvilket
giver dig mulighed for at nå hen til steder som kan være
svære at nå, uden brug af en stige.
Grip godt fat om produktets hoved; løft kontakten
på det øverste håndtag.
Tryk kontakten fast ned for at låse håndtaget
Vigtigt: Batteriet må ikke oplades i et meget koldt rum
(under 5ºC) eller over 40ºC.
4. BRUG
HVORDAN BATTERIPAKKEN BÆRES
Bær bæltet med batteripakken rundt om dit bryst, for at
sikre at den ikke svinger rundt.
START OG STOP
Fig. 1
Håndtaget er designet med en frigøringsknap for at
forhindre opstart ved et uheld.
Fjern bladværnet (6)
Tryk og hold på frigøringsknappen (3), placeret på
begge sider af håndtaget, tryk herefter på
hovedkontakten (2)
Frigør hovedkontakten for at stoppe bladene.
Vent indtil den stopper, før du frigør dit greb om
håndtaget, eller sætter din hånd i nærheden af
skæreområdet.
ANVENDELSE AF BATTERIOPLADEREN
Fig. 2
Batteriet skal afbrydes fra maskinen for at oplader det.
Rotér metalholderringen mod uret
Fjern stikket fra batteriet
Tilslut batteriopladeren korrekt til stikket på
batteriet (se hakket i stikket), og stik opladeren i
hovedkontakten.
Batteriet skal have 12 hele timer for at oplade et
totalt fladt batteri.
Batteriet vil ikke blive beskadiget hvis det oplades i
over 12 timer.
Før første anvendelse, skal batteriet have opladt i
16 timer
Opbevar aldrig produktet med et fladt batteri
HÆKKEKLIPNING - BEDSTE METODE
Det er bedst, hvis hækken er lidt bredere forneden
end foroven. Så kommer der mere lys på hele
hækken, og den forbliver sund. Hvis det er muligt,
bør begge sider af hækken klippes.
Når siderne af hækken klippes, skal der arbejdes
nedefra og opad. På den måde kommer du ikke til at
klippe i grenaffald, du allerede har klippet.
Sværdet må ikke tvinges til at klippe for dybt. Før
hækkeklipperen med let hånd hen over hækkens
overflade.
Klip væk fra dig selv, når du klipper toppen – og ræk
ikke for langt ud. Det er meget bedre og mere sikkert
at klippe uden at række for langt frem og altid blive
stående på begge fødder.
Advarsel: Sørg for, at sværdet ikke kommer i
nærheden af ledningen eller eventuelle hegn. Det kan
beskadige såvel ledning, hegn som hækkeklipper.
OPBEVARING
Når maskinen opbevares i mere end 6 uger:
Aflad batteriet helt (ved at køre produktet), og
genoplad herefter batteriet i mere end 12 timer.
Opbevar i et frostfrit rum.
Genoplad batteriet hver 1 eller 2 måned i
vinterperioden, da langsomt vil aflades.
5. SERVICE & VEDLIGEHOLDELSE
RENGØRING
For at mindske risikoen for elektrisk stød skal ledningen
til opladeren tages ud af stikkontakten, og batteriet tages
ud af opladeren, før opladeren rengøres eller
vedligeholdes.
SMØRING
Redskabet skal ikke smøres.
MILJØ
Batteriet indeholder stoffer, der er giftige. Batteriet skal
afleveres på den lokale genbrugsplads.
FEJL
Hvis der opstår problemer med produktet, eller der
mangler reservedele, kan man kontakte en autoriseret
forhandler.
40 Ferm
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferm HGM1005 - FTHT 12V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferm HGM1005 - FTHT 12V in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info