78366

Ferm FDCD 1800 K2 Manual

6
Zoom out
Zoom in
Previous page
1/48
Next page
Ferm 91
Når du fortsætter med at bruge boret, og batteriet bliver helt afladet, kan den såkaldte
‘ombyttede poler’-effekt forekomme. Batteripolernes polaritet bliver byttet om: ‘+’
bliver til ‘-‘ og ‘-‘ bliver til ‘+’. Er dette først sket, vil polariteten stadig være byttet om
under opladningen, og dette vil skade batteriet uopretteligt.
Hvis akku-boremaskinen ikke skal bruges i en længere periode, skal batteriet
lades helt op forinden. Batteriet skal være opladet under opbevaringen.
5. SERVICE & VEDLIGEHOLDELSE
Sørg for at maskinen ikke står under strøm, når der udføres
vedligeholdelsesarbejder på mekanikken.
Maskinerne er udviklet til at fungere længe uden problemer med et minimum af
vedligeholdelse. Ved at rengøre maskinen regelmæssigt og behandle den korrekt, bidrager
De til en længere levetid for maskinen.
Rengøring
Rengør regelmæssigt maskinkappen med en blød klud, helst efter hvert brug. Sørg for at
ventilationshullerne er fri for støv og snavs. Brug en blød klud, der er vædet i sæbevand til
at fjerne hårdnakket snavs. Brug ingen opløsningsmidler, så som benzin, alkohol,
ammoniak, osv. Den slags stoffer beskadiger kunststofdelene.
Smøring
Maskinen behøver ingen ekstra smøring.
Fejl
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan
bestilles.
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er
så vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
NiCd celler kan genvindes.
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres
på en genbrugsplads.
Garanti
Læs det separat vedlagte garantikort for garantibetingelserne.
GB
D
NL
F
E
P
I
S
FIN
N
DK
Ferm
Important safety notes on charger and batteryblok
If you come into contact with acid from the battery block, rinse it off with water
immediately. If acid gets into your eyes, rinse out your eyes at once with water
and contact a doctor immediately!
1. Read and note the operating instructions and safety notes for the charger and battery
block before use!
2. NB! Only use the charger and battery block that were supplied by the manufacturer -
otherwise you will risk an accident.
3. Protect the charger, battery block and power tool from moisture, e.g. rain or snow.
4. Always check that all cables are connected correctly before using the charger.
5. If you discover that a cable is damaged, you should not use the charger again. Have
the damaged cable replaced immediately.
6. When the charger is not in use, the mains plug should be removed from the power
socket. Do not pull out the plug by grasping the cable.
7. If the charger has been dropped or has otherwise been exposed to high mechanical
stresses, you should have it checked for damage by an authorised dealer before using
it again. Damaged parts should be repaired.
8. Exercise caution when handling the battery block and do not drop it or expose it to
impacts.
9. Never attempt to repair the charger or battery block yourself. Repairs must always be
carried out by an authorised dealer - otherwise you risk an accident.
10. Before cleaning or servicing the charger or battery block, always pull the plug from the
charger socket.
11. Never charge the battery block when the ambient temperature is below 5 °C or above
40°C.
12. The air vents in the charger must never be blocked.
13. The battery block must not be short-circuited.
A short-circuit will cause a high current to flow. This may result in overheating,
the danger of fire or explosion of the battery block. This may damage the
battery block or the user may risk an accident.
Therefore:
• Do not connect any cables to the poles of the battery block.
• Take care that there are no metal objects (nails, paper clips, coins, etc.) on the
contact surface of the battery block.
• Do not expose the battery block to water or rain.
• Only use the battery block supplied in combination with this cordless
drill/screwdriver so as to avoid faults and/or risks to persons.
14. A damaged battery block or one that can no longer be charged must be disposed of
as special waste. Do not discard it with household waste.
15. Never throw the battery block onto a fire or into water. This will risk explosion!
6
GB
D
NL
F
E
P
I
S
FIN
N
DK
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ferm FDCD 1800 K2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ferm FDCD 1800 K2 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info