Ferm 37
Mounting and adjusting the parallel guide
Fig. C
The parallel guide is a handy aid when working on narrow
workpieces.
• Mount the parallel guide. Attach the guide rods (15) on
the frame (14) using the bolts (16).
• Loosen the locking bolts (9) and slide the guide rods in
the openings (8).
• Adjust the parallel guide to the desired guide distance.
• Tighten the locking bolts again.
Mounting the adapter for dust extraction.
Fig. D
Use the adapter for extracting dust.
• Loosen the machine clamp screw (2) and remove the
machine from its base.
• Mount the adapter for dust extraction (18) on the router
base (7) using the screws (17) and nuts (19).
• Replace the maschine into the base.
• Place a vacuum cleaner nozzle on the adapter outlet.
Keep the outlet of the machine behind the
machine for a good view on the workpiece.
OPERATION
Always observe the safety instructions and
applicable regulations.
Hold the machine in rest position on the workpiece when
switching the machine on or off. The cutter in the collet
may damage the workpiece.
• Clamp the workpiece and make sure that the work-
piece cannot slide from under the machine during the
cutting activities.
• Hold the machine firmly and move it evenly over the
workpiece. Do not force the machine.
• Only use cutters which do not show any signs of wear.
Worn cutters have a negative effect on the efficiency of
the machine.
• Always switch off the machine first before removing
the plug from the wall socket.
