Manual Ferm CDM1059 FCDW-1440K2 (page 7 of 52) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

538812

Zoom out

Zoom in

1/52

Ferm

Sørg for, at knappen til rotationsretning (6) altid er i position '', når der skal bores.

Kontroller jævnligt borepatronen for beskadigelse.

Brug eventuelt kølemiddel. Når der bores i vægge, skal man passe på ikke at

komme til at bore i ledninger eller vandrør. Spørg forhandleren om råd vedrørende

brug.

Tænd og sluk

Fig. E

• Tryk afbryderen (7) ind. Maskinens omdrejningshastighed kan reguleres ved at trykke

mere eller mindre på afbryderen.

• Når afbryderen (7) slippes, stopper maskinen straks.

• Sæt knappen til rotationsretning (6) i midterposition for at låse maskinen, så den ikke kan

tændes på afbryderen.

Læg ikke maskinen væk, før der er stoppet helt. Læg ikke maskinen på en støvet overflade.

Støvpartikler kan trænge ind i maskinen.

Brug kun maskinen, hvis knappen til rotationsretning (7) er helt i en af positionerne.

Brug ikke maskinen, hvis denne knap er i neutral position.

Opladning af batterier

Fig. F

Vigtig information om genopladning af varme batterier:

Når du bruger din ledningsfrie slagbore/skruemaskine konstant i længere tid, kan batterierne i

batteripakken blive varme. Du skal lade et varm batteripakke køle ned i ca. 30 minutter før du

starter genopladning. Når batteripakken er afladet og varm, blinker den røde lampe på laderen.

Når batteripakken afkøles, vil den røde lampe lyse konstant for at indikere hurtigopladning,

opladningstid ca. 1 time.

Bemærk: Dette kan forekomme, når konstant brug af dit værktøj forårsager ophedning af

batteripakken. Det forekommer ikke under normale betingelser.

Instruktioner

Tryk batteripakken ned for at sikre, at batteriets poler er i kontakt med laderens kontakter: det

røde ladelys tændes, og opladning starter. Batteripakken kan opvarmes en smule under

opladning. Det er normalt og er ikke tegn på noget problem.

Lysindikator på oplader

• Rødt lys: hurtigopladning

• Rødt lys blinker: batteripakken er fuldt afladt eller ophedet (fjern batteripakken fra laderen

og lad den køle ned).

• Grønt lys: batteripakken er fuldt opladt eller under langsom opladning

• Gult lys tændt og rødt lys blinker: batteriet er defekt (kontakt venligst serviceadressen på

garantikortet).

Ferm 7

In case of failure, the transformer is not dangerous

Thermic protector

Wear ear and eye protection

Never throw batteries into open fire

Always recycle batteries

Faulty and/or discarded electrical or electronic apparatus have to be collected at

the appropriate recycling locations.

Important safety advice concerning the battery pack & battery charger

If you should come into contact with any acid from the Battery pack, wash the

affected parts with water immediately. If acid should come into contact with the eyes,

rinse them immediately with water and seek medical advice as soon as possible.

1. Before using both the battery pack and the battery charger, make sure you have read and

understood the operating instructions and safety information.

2. Only use the battery pack with the battery charger provided – using other chargers could

be dangerous.

3. Keep the battery pack, tool and battery charger away from damp and wet conditions.

4. Before using the battery charger, check all wires are properly connected.

5. If any wires on the charger are damaged, do not use it until these have been replaced.

6. When the charger is not in use it should not be plugged in. When unplugging, do not pull the

plug out by the cable.

7. If the charger breaks down or suffers from other technical problems, take it to a recognised

dealership to be checked before using it again. Any damaged parts must be replaced.

8. Take care when handling the battery pack, do not drop it or knock it against other things.

9. Never attempt to repair the battery charger or battery pack yourself; this can be extremely

dangerous. Repairs should always be carried out by a recognised dealership.

10. Always unplug the charger before cleaning or carrying out any other maintenance on it.

11. Do not attempt to charge the battery pack in temperatures of below 5 degrees or above 40

degrees centigrade.

12. The air vents on the battery charger must be kept unblocked.

13. The battery pack must not be short-circuited.

When an apparatus short-circuits, the strength of the electric current is increased.

This can cause the apparatus to over heat, catch fire or even explode, causing

damage and also endangering the operator.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ferm CDM1059 FCDW-1440K2 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 8,07 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ferm CDM1059 FCDW-1440K2 Manual

Product: