470120
3
Zoom out
Zoom in
Previous page
1/7
Next page
The front panel contains all items necessary for system
operation and observation. Please read this section of the
manual carefully to make sure you understand all the
operational features of your new Fender BXR 300. The Front
Panel is similar for both the 300R and 300C.
(A) INPUT: Two inputs are provided;
Input 1 -
High gain
Input 2 -
Low gain
The high gain input (INPUT 1) should be used for most
instruments. This input can handle as much as 3.5 volts
R.M.S., while the low gain input (INPUT 2) accepts 7 volts
R.M.S. without audible distortion. For both cases this is
greater than any active bass with a 9 volt battery can
produce. if you are using a bass with dual 9 volt batteries, or
a "hot" passive bass it might be wise to try input 2. For the
rare case where two players want to use one amplifier, or
where two instruments are to be used during the
performance, both inputs may be used.
(B) ENHANCE:
HIGH ENHANCE
provides high frequency
boost.
LOW ENHANCE
provides low frequency boost, while
eliminating sub-sonic noises below 40 Hz.
(C) VOLUME: This control sets the gain of the preamp and
serves as an adjustment for the "loudness" of the amplifier.
(D) TREBLE: - adjusts the high frequency part of the spectrum.
Turning the treble up will cause the sound to become
"BRIGHT" or more "CRISP".
FRONT PANEL DESCRIPTIONS
(E) MID: - Can be used to add or subtract the frequency range
set by MID FREQUENCY control.
(F) MID FREQUENCY: - Adjusts the frequency of boost or cut
by the MID control.
(G) BASS - adjusts the low frequency part of spectrum, the
area where the "deep" fundamental reside.
(H) PREAMP OUT: The preamp jack is a source of signal as it
appears at the power amp input. This jack can be used as a
"LINE OUT" or as a "SEND" point for an external effects
device.
(I) POWER AMP IN: Use of this jack allows the default input
signal from the preamp to be replaced by an external source,
(usually the "return" from an effects device).
(J) DELTACOMP™: With this button in, DELTACOMP™ is
active, in the out position, DELTACOMP™ is deactivated,
and a special ASYMMETRIC LIMITER circuit is enabled. The
LED next to this button indicates that the power amplifier has
reached full power and that either DELTACOMP™ or
LIMITING has occurred, depending which position that the
switch is in. The unit may seem louder without DELTACOMP™
since the power amp will be allowed to go into clipping. With
DELTACOMP™ on, your volume level will be rather loud
before the compressor turns on; this is normal.
(K) POWER: Turns the BXR 300 on or off.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fender BXR 300C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fender BXR 300C in the language / languages: English as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info