534811
14
Zoom out
Zoom in
Previous page
1/61
Next page
14
en
When wet vacuuming, operate the vacuum cleaner only
when the container is level. Otherwise there is danger of
electric shock from water penetrating into the vacuum
cleaner motor.
Do not misuse the power supply cord to pull the vacuum
cleaner around or pull the mains plug from the socket out-
let. Keep the power supply cord away from heat, oil, sharp
edges, or rotating parts. Do not drive over or pinch the
power supply cord. Damaged or entangled power supply
cords increase the risk of an electric shock.
Before replacing accessories, pull the mains plug from the
socket outlet. This safety measure reduces the risk of
electric shock.
Do not vacuum materials that are hazardous to one’s
health, e. g., dust from beech or oak wood, masonry dust,
asbestos. These materials are considered carcinogenic.
Do not vacuum inflammable or explosive fluids; for exam-
ple, benzene, oil, alcohol, solvents. Do not vacuum hot or
inflammable dusts. Do not operate the machine in rooms
where the danger of an explosion exists. The dusts,
vapours or fluids can ignite or explode.
Do not rivet or screw any name-plates or signs to the vac-
uum cleaner. If the insulation is damaged, protection
against an electric shock will be ineffective. Adhesive
labels are recommended.
Do not use accessories not specifically intended and recom-
mended for this vacuum cleaner by FEIN. Just because the
accessory can be attached to your vacuum cleaner, it
does not assure safe operation.
Before putting into operation, check the mains connection
and the mains plug for damage.
Please also observe the operating instructions and safety
warnings of the power tool being connected to the socket
outlet of the vacuum cleaner.
Operating instructions.
The motor of the vacuum cleaner is equipped with a soft-
start function.
When inserting a paper-dust bag, take care that the card-
board flange and the paper-dust bag face completely
against the inside wall of the container.
After removing the paper-dust bag, seal it with the clos-
ing cover in order to avoid debris.
Keep the filter cartridge dry and clean it regularly.
Mount accessories applying only slight pressure. For dis-
assembling, turn the parts somewhat against each other
and pull apart.
The vacuum cleaner starts with the last set suction capac-
ity.
Switch the vacuum cleaner off before connecting a
power tool to the vacuum cleaner’s socket outlet. Make
sure that the power tool is switched off when inserting
its plug into the vacuum cleaner’s socket outlet.
After switching off a power tool connected to the vac-
uum cleaner’s socket outlet, the vacuum cleaner will run
on for approx. 5 seconds and then automatically switch
off.
When wet vacuuming, the air flow is interrupted by
means of a float after reaching the maximum filling height.
Switch off the vacuum cleaner immediately, pull the
mains plug from the socket outlet and empty the con-
tainer.
Switch the vacuum cleaner off immediately as soon as
foam or water comes out, and empty the container.
Repair and customer service.
When replacing the power tool’s cable is required, have
this carried out by FEIN or by an authorized FEIN Service
Agent, in order to avoid hazardous situations.
Empty the container each time after using and remove
coarse debris and dust.
Empty the container after vacuuming liquids. Afterwards,
run the vacuum cleaner with the accessories connected
for several minutes in order to dry them.
Fault finding.
Malfunction description Cause Troubleshooting
Vacuum cleaner cannot be switched on. Circuit breaker has tripped. Ensure power supply.
Vacuum cleaner in remote
control operation.
Set operating-mode selector to “I”.
Reduced vacuuming capacity. Vacuum cleaner not fitted
correctly.
Mount vacuum lid and shut both
fasteners completely.
Vacuum system clogged. Clean vacuum hose and extension
tubes.
Paper-dust bag full. Replace paper-dust bag.
Filter cartridge dirty/soiled. Clean or renew filter cartridge.
No suction capacity when wet vacuuming. Container full. Empty container.
3 41 01 115 06 0.book Seite 14 Donnerstag, 18. Dezember 2008 8:51 08
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fein Dustex 40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fein Dustex 40 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info