522127
50
Zoom out
Zoom in
Previous page
1/89
Next page
9.4. Power Supply Connection
Plug the pre-assembled cable supplied into the socket at the
rear. The clip on connection is self-locking, however for safety
reasons it is advisable to secure with the pre-set screws. The earth
wire (yellow/green) must be screwed to the GROUND
connection.
The unit was manufactured to operate on a supply voltage of
11V to 15V DC (12V battery). The FMD55 has reverse battery and
over voltage protection. Should an incorrect connection take
place, check the fuse and if necessary, replace.
The power cable is shielded to suppress disturbances. The open
end is ready for connection and is fitted with a terminal strip.
The connection should be as near as possible to the distribution
panel or the battery. It is most important, that the current is
completely free of interference. Should there be any doubt, we
recommend, that you fit a suppression filter.
Fit the cable as follows:
x brown :(-) minus pole 12volt battery
x white :(+) plus pole 12 volt battery
x yellow/green : earth (ground plate)
Before switching on, we recommend you to test the polarity and
the voltage at the terminals on the unit.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fastnet FMD55P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fastnet FMD55P in the language / languages: English as an attachment in your email.

The manual is 1,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fastnet FMD55P

Fastnet FMD55P User Manual - German - 103 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info