784935
12
Zoom out
Zoom in
Previous page
1/24
Next page
9
ELECTRICAL REQUIREMENTS
CIRCUIT BREAKER
REQUIREMENTS:
A new GFCI circuit breaker must be used for your
spa installation. Do not use an existing breaker,
as its condition is unknown.
The 230V 50Hz systems use a single electrical
service (one 13 amp or one 20 amp breaker) using
3 wires. The 3 wires are 1 line (brown) + 1 neutral
(blue) + 1 protective earth (green/yellow) ON either
system, the spa must be connected to a dedicated
GFCI circuit breaker that is not shared with any
other equipment. Do not use extension or plug
type cords of any kind.
CONFIGURING SYSTEM
CONFIGURING YOUR SPA TO 13 OR
20 AMP SYSTEM:
When using a 230V 50Hz 13 amp or 20 amp
system, attach the wires to the terminals as shown
below.
On a 13 amp system, the spa heater will ONLY
work when the pump is in the low speed.
Using a 20 amp system will allow the heater to
work when the pump is in either the low or high
speed.
IMPORTANT: After powering up the spa when using a 20 amp system, a program configuration is
required. Press and Hold JETS button for 30 seconds to access the Low Level (LL) settings on the control
panel. Use the +/- button to change the setting from LL1 Factory Default (non concurrent heat and high
speed) to LL2 (concurrent Heater and High Speed pump) configuration. Press the LIGHT button within 25
seconds to save the new program setting.
Blue
Brown
Green
Breaker
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fantasy Splendor 2019 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fantasy Splendor 2019 in the language / languages: English as an attachment in your email.

The manual is 0.56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info