784936
4
Zoom out
Zoom in
Previous page
1/24
Next page
IMPORTANT SAFETY
INSTRUCTIONS
READ AND FOLLOW ALL
INSTRUCTIONS
AVOIDING THE RISK TO CHILDREN
DANGER:
RISK OF CHILD DROWNING. Extreme
caution must be exercised to prevent
unauthorized access by children. To avoid
accidents, ensure that children cannot use
a spa unless they are supervised at all
times.
WARNING:
To reduce the risk of injury, do not permit
children to use this product unless they
are closely supervised at all times.
To reduce the risk of injury, lower water
temperatures are recommended for young
children. Children are especially sensitive
to hot water.
DO:
Make sure you always lock the child
resistant locks after using the spa for your
children’s safety. Every spa is equipped
with a locking cover that meets the ASTM
F1346-91 Standard for Safety Covers.
Test the water temperature with your hand
before allowing your child to enter the spa
to be sure that it’s comfortable. Children
are especially sensitive to hot water.
Remind children that wet surfaces can be
very slippery. Make sure that the children
are careful when entering or exiting the
spa.
DON’T:
Allow children to climb onto the spa cover.
Allow children to have unsupervised
access to the spa.
AVOIDING THE RISK OF
ELECTROCUTION
Risk of Electrocution
Connect only to a grounded source.
Do not bury the power cord. A buried
power cord may result in death or serious
personal injury due to electrocution if direct
burial-type cable is not used, or if improper
digging occurs.
A ground terminal (pressure wire
connector) is provided on the control box
inside the unit to permit connection of a
minimum 6 mm² solid copper bonding
conductor between this point and any
metal equipment, metal water pipe, metal
enclosures of electrical equipment, or
conduit within five feet (1.5 m) of the
unit as needed to comply with local
requirements.
WARNING:
To reduce the risk of electrical shock,
replace a damaged cord immediately.
Failure to do so may result in death
or serious personal injury due to
electrocution.
Your spa is provided with a Ground Fault
Circuit Interrupter for user and equipment
protection. To ensure proper operation of
this important safety device, test according
to the following instructions per electrical
configuration.
A ground terminal is provided on the
control box. To reduce the risk of electric
shock, connect this terminal to the
grounding terminal of your electrical
service or subpanel with a continuous
green, insulated copper wire. The wire
must be equivalent in size to the circuit
conductors supplying the equipment. In
addition, a bonding terminal (pressure wire
connector) is provided on the outside of
the control box for bonding to local ground
points. To reduce the risk of electric shock,
this connector should be bonded with
a 8 mm² solid copper wire to any metal
1
SAFETY INFORMATION
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fantasy Embrace 2019 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fantasy Embrace 2019 in the language / languages: English as an attachment in your email.

The manual is 0.56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info