Manual Falmec Domino 38 (page 16 of 48) (English, German, Danish, French, Italian, Polish, Spanish)

709881

Zoom out

Zoom in

1/48

ADDITIONAL FUNCTIONS

"38 PLUS" MODEL

STOP AND GO

This function allows to temporarily stop cooking and restore it with the same settings.

to enable touch the key

If the function is not deactivated within 10 minutes, the cooker switches o.

For deactivation

Touch the key and within 5 seconds completely slide the slider to right.

AUTOMATIC PROGRAMMING OF THE COOKING

This function allows to speed up the start of cooking.

The procedure is the following:

1 - turn on the cooker

2 - touch for more than 2 seconds the desired level of cooking:

on the display

will be displayed and the desired level of cooking .

For a certain period the cooking area will work at the maximum power to then rech the

set level.

To deactivate the function:

touch again the control .

RESTORE FUNCTION

After turning o the cooker, it is possible to restore the last selected settings:

· Status of cooking of all cooking areas (power).

· Minutes and seconds of the timer by programmed cooking areas.

· Automatic programming of cooking.

The restore procedure is the following:

- turn on the cooker.

· touch within 6 seconds the key

Previous settings are restored.

WHAT TO DO IN CASE OF PROBLEMS

The cooker or cooking areas do not turn on:

· The cooker is not connected to the electric network.

· The protection fuse is released.

· Check if the block is not active.

· Keys are covered with water or grease.

· An object is placed on the keys.

The symbol is displayed

· There is no saucepan on the cooking area.

· The container used is not compatible with cooktops.

· The diameter of the saucepan bottom is too small compared to the cooking area.

The symbol [E] is displayed:

· Disconnect and connect the cooker.

· Contact the after-sales centre.

One of the area or the entire cooker turns o:

· The safety overheating system is active;

· The cooker or one cooking area remains on for too long;

· one or more keys are covered;

· one of the saucepans is empty and the bottom overheated.

The fan keeps on working after the cooker shutdown:

· This is not a malfunction: the fan keeps on protecting the electronic power unit of the

device.

· The fan stops automatically.

The symbol [E2] or [E H] is displayed:

· The cooker overheated, leave it cool and then turn it on again.

The symbol [E6] is displayed:

· Defective electrical network. Check the network voltage and frequency.

The symbol [E8] is displayed:

· The air inlet of the fan is clogged, clean it.

CLEANING AND MAINTENANCE INSTRUCTIONS

ATTENTION!

For cleaning, never use a steam equipment.

Before cleaning the cooker, make sure that it is at room temperature.

Always clean the cooker after each use with a specic cleanser for pyroceram.

Do not use products containing:

- corrosive agents (soda, acids, ammoniac).

- abrasive agents (dusts or paste).

Do not use pointed or abrasive objects.

After cleaning, dry the appliance with a soft cloth.

If the appliance is built-in over an oven or an electric kitchen tted with pyrolytic system

do not operate it while the pyrolytic procedure is under way, as the overheating protec-

tion of the cooker can be released (see relevant chapter).

DISPOSAL AFTER END OF USEFUL LIFE

The crossed-out wheeled bin symbol on the appliance means that the product

is WEEE, i.e. "Waste electrical and electronic equipment", accordingly it must not

be disposed of with unsorted waste (i.e. with "mixed household waste"), but it

must be disposed of separately so that it can undergo speciﬁc operations for its

re-use, or a speciﬁc treatment, to remove and safely dispose of any substances that may be

harmful to the environment and remove the raw materials that can be recycled. Proper dis-

posal of these products contributes to saving valuable resources and avoid potential nega-

tive eﬀects on personal health and the environment, which may be caused by inappropriate

disposal of waste.

You are kindly asked to contact your local authorities for further information regarding the

designated waste collection points nearest to you. Penalties for improper disposal of such

waste can be applied in compliance with national regulations.

INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES

The EU WEEE Directive was implemented diﬀerently in each country, accordingly, if you wish

to dispose of this appliance we suggest contacting your local authorities or dealer to ﬁnd

out what the correct method of disposal is.

INFORMATION ON DISPOSAL IN NONEUROPEAN UNION COUNTRIES

The crossed-out trash or refuse bin symbol is only valid in the European Union: if you wish

to dispose of this appliance in other countries, we suggest contacting your local authorities

or dealer to ﬁnd out what the correct method of disposal is.

WARNING!

The Manufacturer reserves the right to make changes to the equipment at any time and

without prior notice. Printing, translation and reproduction, even partial, of this manual are

bound by the Manufacturer's authorisation.

Technical information, graphic representations and speciﬁcations in this manual are for in-

formation purposes and cannot be divulged.

This manual is written in Italian. The Manufacturer is not responsible for any transcription

or translation errors.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Falmec Domino 38 in the language / languages: English, German, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 8,12 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Falmec Domino 38 Manual

Product: