610137
17
Zoom out
Zoom in
Previous page
1/20
Next page
1. Alle Kabel an die Steuerung anschließen
2. Die Steuerung an 16 Volt Wechselspannung
anschließen. Die Gondel fährt nun automatisch
nach unten bis zur Talstation.
3. Wird die Startfunktion der Steuerung betätigt
(z. B. über einen Drucktaster, Sensor, etc.) fährt
die Gondel zur Bergstation.
4. Nach einer kurzen Pause fährt die Gondel
wieder bis zur Talstation. Zum erneuten Starten
der Gondel wie in Punkt 3 vorgehen.
1. Connect all cables to the control unit.
2. Connect the control unit to 16 volts alternating
current. Now, the gondola automatically moves
downwards to the valley station.
3. If the Start function is actuated in the control
unit (e.g. via a push button, a sensor, etc.) the
gondola will move up to the mountain station.
4. After a short pause the gondola will move
again downwards to the valley station.
To cause the gondola start again, proceed
as indicated under point 3.
1. Connecter tous les câbles à la commande.
2. Connecter la commande à 16 volts courant
alternatif. La nacelle va maintenant descendre
automatiquement jusqu’à la station de vallée.
3. Si la fonction Start de la commande est
actionnée (p. ex. par un bouton-poussoir,
un capteur, etc.) la nacelle montera à la
station de montagne.
4. Après une courte pause, la nacelle redescendra
jusqu’à la station de vallée. Pour faire redé-
marrer la nacelle, procéder comme au point 3.
1. Alle draden op de besturing aansluiten
2. De besturing op 16 volt wisselspanning
aansluiten. De gondel gaat nu automatisch
naar beneden tot het dalstation.
3. Als de startfunctie van de besturing wordt
ingeschakeld (bijv. via een drukknop, sensor etc.)
gaat de gondel naar het bergstation.
4. Na een korte pauze gaat de gondel weer naar
beneden. Om de gondel opnieuw te starten,
de instructies bij punt 3 opvolgen.
rot
red
rouge
rood
16 V AC
Motor
blau
blue
bleu
blauw
Taster/ Sensor
liegt nicht bei
Button/Sensor
not included
Bouton/Capteur
non jointe
Knop/sensor
niet bijgevoegd
17
B
D
E
ni
c
ht k
l
eben
do not g
l
u
e
ne
pas
col
l
er
ni
et
l
i
j
men
17


Need help? Post your question in this forum.

Forumrules
1

Forum

faller-232372-material--und-personenseilbahn

Reset search

  • I have a problem with page 12 of instruction, What is the wire or line used , totally stuck here Submitted on 20-8-2022 at 23:23

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for FALLER 232372 Material- und Personenseilbahn at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of FALLER 232372 Material- und Personenseilbahn in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info