71518
46
Zoom out
Zoom in
Previous page
1/60
Next page
46
English
The side panels of either oven can be removed.
Each side of the oven is fi xed with four fi xing screws. You don’t
have to remove the screws to remove the oven linings. Lift each
side panel upwards and they will slide off the screws. Then pull
them forwards.
Once the linings are removed, the oven enamel interior can be
cleaned.
Troubleshooting
Steam is coming from the oven
When cooking foods with a high water content (e.g. oven chips)
there may be some steam visible at the rear grille. Take care when
opening the oven door, as there may be a momentary puff of
steam when the oven door is opened. Stand well back and allow
any steam to disperse.
The oven fan is noisy
The note of the oven fan may change as the oven heats up - this
is perfectly normal.
What cleaning materials are recommended for the
cooker?
See the ‘Cleaning section for recommended cleaning materials.
We do not recommend Mr. Muscle, as it contains chemicals that
may damage the surfaces of your cooker.
Grill not cooking properly
Are you using the pan and trivet supplied with the cooker?
Is the pan being used on the runners, not the fl oor of the
compartment? Is the grill pan pushed fully back to stop?
When you pull the grill pan forward is the wide rim at the front?
It's important that the wider part is at the front.
The knobs get hot when I use the oven or the grill,
can I avoid this?
Yes, this is caused by heat rising from the oven or the grill, and
heating them up. Don’t leave the oven door open. Make sure that
the grill pan is pushed right back to the ‘back stop when grilling.
If there is an installation problem and I don’t get my
original installer to come back to fix it who pays?
You do. Service organisations will charge for their call-outs if they
are correcting work carried out by your original installer. Its in
your interest to track down your original installer.
Current Operated Earth Leakage Breakers
Where the cooker installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined use of
your cooker and other domestic appliances may occasionally
cause nuisance tripping. In these instances the cooker circuit may
need to be protected by fi tting 100mA device. This work should
be carried out by a qualifi ed electrician.
Power failure
In the event of a failure in the electrical supply the hotplate may
be lit using a match.
Food is cooking too slowly, too quickly, or burning
Cooking times may diff er from your previous oven. Check
that you are using the recommended temperatures and shelf
positions. See the oven cooking guide. The oven control settings
and cooking times are intended to be used only as a guide.
Individual tastes may require the temperature to be altered
either way, to get the results you want. Try cooking at a higher
temperature setting.
The oven is not cooking evenly
Do not use a tin or baking tray larger than 340mm x 340mm.
If you are cooking a large item, be prepared to turn it round
during cooking.
If two shelves are used, check that space has been left for the
heat to cir cu late. When a baking tray is put into the oven, make
sure it is placed centrally on the shelf.
Check that the door seal is not damaged and that the door catch
is adjusted so that the door is held fi rmly against the seal.
A dish of water when placed on the shelf should be the same
depth all over. (For example, if it is deeper at the back, then the
back of the cooker should be raised up or the front lowered). If
the cooker is not level arrange for your supplier to level it for you.
The left hand Multifunction oven not coming on
when turned on manually
Is the power on? Is the clock illuminated?
If not there may be something wrong with the power supply. Is
the cooker supply on at the isolator switch?
Has the time of day been set?
Have you set a cooking function?
Is the key symbol (
) showing in the display? See the Clock
section of the instructions for more information on the key lock
feature of the clock.
The left hand Multifunction oven not coming on
when automatic cooking
Timer set correctly but oven knob left OFF by mistake?
Is the key symbol (
) showing in the display? See the Clock
section of the instructions for more information on the key lock
feature of the clock.
Have you set a cooking function?
Oven temperature getting hotter as the cooker gets
older
If turning the knob down has not worked or only worked for a
short time then you may need a new thermostat. This should be
tted by a service person.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Falcon Excel 110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Falcon Excel 110 in the language / languages: English, German as an attachment in your email.

The manual is 2,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Falcon Excel 110

Falcon Excel 110 User Manual - Dutch - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info