500343

Falcon De Luxe 1000DF Manual

21
Zoom out
Zoom in
Previous page
1/56
Next page
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
21
d) Remove the tap. Remove and discard the gasket seal.
Fit new gasket seal to replacement tap.
e) Re-assemble in reverse order. Check the appliance is
gas sound. Check hotplate ignition.
9 To Change an Ignition Switch
Change the gas tap as detailed in Section 8.
10 To Remove a Hotplate Burner Injector
a) Remove the hotplate as detailed in Section 1.
b) Remove the injector directly from the burner body.
c) Fit the appropriate injector.
d) Re-assemble in reverse order. Check the appliance is
gas sound.
11 To Remove a Hotplate Burner Spark
Electrode
a) Remove the pan supports, hotplate accessories and
burner heads.
b) Undo the bezel venturi and remove the bezel from the
hotplate. The spark ignition wire will be pulled through
the electrode clearance hole.
c) Disconnect the spark electrode from the ignition wire.
Note
Take care to prevent the ignition wire from falling back
through the clearance hole.
d) Undo the spark electrode from the bezel by removing
the spring clip and spring.
e) Fit the replacement electrode to the burner bezel.
Ensure that the spring and clip are properly located.
f) Replace in reverse order and check correct burner
ignition.
12 To Remove a Hotplate Burner
a) Remove the pan supports, hotplate accessories and
burner heads.
b) Remove the hotplate as detailed in Section 1.
c) Remove the nut that secures the burner body to the
support channel.
d) Remove the fi xings that secure the support channel to
the chassis. Lift the channel clear of the appliance.
e) Undo the compression fi tting which connects the
burner body to the gas pipe. Remove the burner body
from the appliance.
f) Replace in reverse order. Check the appliance is gas
sound and that the burner operates satisfactorily.
13 To Remove the Oven Door
a) Open the oven door.
b) Rotate hinge locking disc 90° clockwise on both door
hinges to lock door in open position.
c) Carefully close door and at approximately half closed
the hinges will release themselves from the cooker
frame.
d) Re-assemble in reverse order.
14 To Remove the Oven Outer Door Panel
a) Remove the door from the cooker (see section 13).
b) Remove screws holding the outer panel to the door.
c) Remove the outer door panel.
d) Undo the nuts that secure the handle to the door
panel. Fit the handle to the replacement door panel.
e) Fit the replacement panel to the oven inner door
making sure that the door insulation is correctly
located.
f) Re-assemble in reverse order.
15 To Remove the Oven Door Seal
a) Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook is
released.
b) Proceed to the next hook and release it in a similar
way, and so on. Use force if the hooks are stiff, as the
old seal will be discarded.
c) Hook the new seal in one of the corner holes of the
door, and proceed round the door opening snapping
in each hook in turn.
16 To Remove the Hotplate Electrode Leads
Disconnect from the electricity supply.
Pull the unit forward to access the rear of the appliance.
a) Remove the pan supports, hotplate accessories and
burner heads.
b) Remove the hotplate as detailed in Section 1.
c) Remove the cover box and disconnect all HT leads at
the generator.
d) Pull the sleeved bundle of HT leads up through the
rear upright.
e) Pull the appropriate lead from the sleeve and push in
the replacement.
f) Replace the leads in the rear upright.
g) Re-connect the leads at the generator.
h) Re-assemble in reverse order and check ignition.
17 To Remove Spark Generator
a) Isolate from electric supply.
b) Lower front mobility wheels (see section ‘MOBILITY
WHEELS’ in Users instructions) and pull cooker
forwards to gain access to the rear of the cooker.
CAUTION: DO NOT STRAIN FLEXIBLE GAS
CONNECTION disconnect if necessary.
c) Remove mains cable inlet cover, 8 screws.
d) Disconnect electric cables to generator.
e) Remove two screws securing generator mounting
bracket to cooker frame and carefully withdraw
generator suffi ciently to disconnect electrode leads.
f) Re-assemble in reverse order.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Falcon De Luxe 1000DF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Falcon De Luxe 1000DF in the language / languages: English, French as an attachment in your email.

The manual is 5,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info