500342

Falcon 1092 CT Dual Fuel Manual

22
Zoom out
Zoom in
Previous page
1/36
Next page
22
You will need the following equipment
to complete the cooker installation
satisfactorily
STABILITY BRACKET
If the cooker is to be supplied
with gas through a fl exible
hose, a stability bracket or
chain must be fi tted.
These are not supplied by with the cooker
but are available at most builders’ merchants.
GAS PRESSURE TESTER
FLEXIBLE GAS HOSE
Must be in accordance
with the relevant
standards.
MULTIMETER
(for electrical checks)
You will also need the following tools:
1. Electric drill
2. Masonry drill bit & Rawlplugs
(only required if fi tting the cooker on a stone or
concrete fl oor)
3. Steel tape measure
4. Cross head screwdriver
5. Flat head screwdriver
6. Spirit level
7. Pencil
8. Adjustable spanner
9. Screws for fi tting stability bracket
Positioning the Cooker
The diagrams show the minimum recommended distance
from the cooker to nearby surfaces.
The cooker should not be placed on a base.
*door opening width - the door corners swing slightly outside the
cooker width
The hotplate surround should be level with, or above,
any adjacent work surface. Above hotplate level a gap of
75mm should be left between each side of the cooker and
any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 800mm is required between the top
of the hotplate and a horizontal combustible surface.
*Any cooker hood should be installed in accordance with the
hood man u fac tur er’s instructions.
Surfaces of furniture and walls at the sides and rear of
the appliance should be heat, splash and steam resistant.
Certain types of vinyl or laminate kitchen furniture are
particularly prone to heat damage and discolouration.
We cannot accept responsibility for damage caused
by normal use of the cooker to any material that de-
laminates or discolours at temperatures less than 65°C
above room temperature.
For safety reasons curtains must not be fi tted im me di ate ly
behind the cooker.
We recommend a gap of 1110mm between units to allow
for oven door opening and moving the cooker . Do not
box the cooker in; it must still be possible to move the
cooker in and out for cleaning and servicing.
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Falcon 1092 CT Dual Fuel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Falcon 1092 CT Dual Fuel in the language / languages: English as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info