12
OPERATING
Having selected and installed the desired accessory, check
to ensure that the interior of the appliance (A) and all the ac-
cessory compenents are dry. • Unwind the mains lead and
install the plug into the power socket.
• Switch on the appliance by lightly
pressing the ON/OFF switch.
B- Suction Power Control - An air intake control is located
in the handle of the suction hose with which you can reduce
the suction power if e.g. the carpet or mat lifts from the floor
under excessive suction power. For Max. Suction Power
- Push control slide forward (aperture in handle closed).
For Min. Suction Power - Push the control slide to the rear
(aperture in handle open).
C- Release the canister clamps, remove hood, filter car-
tridge and paper filter if fitted. To remove the filter, turn the
filter retaining clip anticlockwise and pull off the filter car-
tridge togeher with the base plate.
D- Foam Plastic Filter - Install the foam plastic filter if it is
intended to remove a mixture of liquid and dirt or waste
matter. To do this, push the filter on to the float valve
retainer as far as it will go. Slightly contaminated water can
be removed without installing the foam plastic filter. Place
the hood an the canister, fasten the canister clamp and in-
stall the desired cleaning accessory.
• Unwind the mains lead and install the plug into the
power socket.
• Switch on the appliance by light pressure on the On/OFF
switch.
Dry vacuum cleaning
Wet vacuum cleaning
en
