16
After use
● After cleaning, put on the drive belt and insert the
brush roller and bearings so that they fit accurately.
When inserting the bearing holders, make sure that
both show the same marking [P]:
1 cam = new brush roller
8 notches = half-worn brush roller
● Place bottom plate on housing and secure, making
sure that the levers lock into the front edge of the
housing.
Flat belt: Premium 1107, Combi 17-30
Toothed belt: Combi 17-36, 17-46
Cleaning and replacing
brush roller and drive
belt
P
P
N
N
O
WARNING!
Switch off and unplug the appliance before beginning cleaning or main-
tenance. If the mains plug is plugged in, the appliance could accidental-
ly be switched on, resulting in injuries.
To keep the electronic suction brush working efficiently,
you should remove hair, fibres and threads, etc. at
regular intervals from the brush roller and, if necessary,
from the drive belt.
● To remove the bottom plate, turn the levers [N] until
they are horizontal.
On Model 17-46, also remove the screw [O].
● Hold the brush roller firmly on both ends, lift together
with the bearings and withdraw it laterally from the
drive belt.
● Remove hair, fibres, threads, etc. which have wound
around the brush roller, using a knife or scissors.
Thoroughly clean the brushes of the roller and the dri-
ve belt (brush off and or vacuum clean).