10
Directions for use
Remove the vacuum cleaner from the wall holder.
To switch on, push the on/off switch forward and hold it in that position. It can now be used
to vacuum dirt and dust.
The motor will stop automatically when you release the on/off switch.
Crevice nozzle :
The crevice nozzle is an effective attachement for vacuuming deep
slots in upholstery, skirting boards, ledges, corners etc.
Wet nozzle :
Before vacuuming liquid or wet dust, remove the filter and insert the wet
nozzle (which permits the vacuuming of liquids) in the aperture in the
suction nozzle.
If the suction power of the appliance diminishes or fades away completely after a time,
recharge it. Always recharge the battery immediately after use. That way you will obtain
the best possible performance from the appliance and prevent shortening the service life
of the battery module.
After use
You are recommended to empty the filter after every vacuuming operation.
Removing the filter:
Press the release button and pull the suction nozzle off downwards while swive-
ling it.
Remove the filter from the suction nozzle.
Shake the dust and dirt of the suction nozzle and of the filter into a refuse bin.
In the case of stronger contamination of the filter and of the suction nozzle you can wash
this with a mild cleaning agent. Make sure that the filter and suction nozzle are comple-
tely dry before renewed use.
Inserting the filter:
Insert the filter in the suction nozzle and fit the suction nozzle back on the motor part until
it snaps noticeably into place. Your battery vacuum cleaner and now ready again.
Changing the battery module
The battery vacuum cleaner is equipped with a replaceable battery module which can be
recycled. Before removing the battery module, leave the unit in the switched on conditi-
on until the battery is "empty".
• Remove the battery compartment lid upwards.
• Remove the battery module and loosen the two connectors.
• Connect the new battery module and pay attention to correct polarity:
Plus pole = red lead to connection marked red
Minus pole = black cable to connection marked black
When inserting the battery module in the motor housing, first insert the side with the
connection leads.
5
7
6
