545246

Fakir IC 1035 Manual

11
Zoom out
Zoom in
Previous page
1/28
Next page
11
Exchange of filter
Cleaning the brush roller
Replacing the drive belt
To achieve a high efficiency of the electric suction brushes, you should regularly remove
hairs, fibres, threads, etc. from the brush rollers and if necessary from the drive belts.
Always switch the battery vacuum cleaner off before you start cleaning.
Remove the electric suction brush from the basic unit.
Pull the locking slides on both sides of the electric suction brush simultaneously to
the front and remove the front cover of the housing.
Hold the brush roller firmly at both ends, lift it up together with the bearings and
withdraw it laterally from the drive belt.
Remove hair, fibres, threads, etc. which have wound round the brush roller with a
knife or scissors. Thoroughly clean the brushes of the roller and the drive belt
(brush off and / or vacuum clean)
After cleaning place the drive belt in position, insert the brush roller with bearings
accurately, attach and lock the cover.
Note :
Before replacing the drive belt remove the rear housing cover by loosening the five
screws on the bottom of the electric suction brush. Take care before screwing together
that the new drive belt is located correctly over the drive pinion of the motor.
Changing the battery
The battery vacuum cleaner is equipped with a replaceable battery block which can be
recycled. This can be charged up to around 1000 times. After this or in the case of an ear-
lier defect, the battery block must be delivered to a collecting point for used batteries.
Before removing the battery, leave the unit in the switched on condition until the battery
is "empty".
Push the two locking catches to the back and remove the battery compartment lid
upwards.
Remove the battery black and loosen the two connectors.
Connect the new battery block and pay attention to correct polarity:
Plus pole = red lead to connection marked red
Minus pole = black cable
When inserting the battery block in the motor housing, first insert the side with the
connection leads.
11
12
13
14
15
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fakir IC 1035 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fakir IC 1035 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info