465116

Fagor Splendid Manual

18
Zoom out
Zoom in
Previous page
1/76
Next page
18
Troubleshooting
In order to ensure best results when using the Fagor SPLENDID pressure cooker, be
certain to read all of the instructions and safety tips contained in this owner’s manual and
all other printed materials provided by the manufacturer. The following are practical tips
and solutions to some common problems you may experience when using the Fagor
SPLENDID pressure cooker.
PROBLEM:
REASON:
SOLUTION:
The lid got jammed while trying to slide it closed, and will not open or close.
If the instructions in the “Closing the Lid and Cooking” section of this manual were
not followed carefully, the lid might get jammed while trying to close it.
If there is some resistance when attempting to slide the lid closed, do not force it.
Stop, slide it back, lift the lid and try aligning the marks again as described in the
“Closing the Lid and Cooking” section of this manual.
If the lid jams, never try to force it closed. To un-jam try sliding the lid open again.
If you cannot open it, please contact the Fagor Customer Service Department at:
1-800-207-0806 or email at: info@fagoramerica.com.
PROBLEM:
REASON:
SOLUTION:
There is water leaking from the lower handle while the cooker is building
pressure.
While the pressure cooker is building pressure, a little water might drip from around
the area of the pressure lock on the pot handle. The water comes from steam
condensed on the inside of the lid. The dripping will stop when the pressure cooker
reaches full pressure. However, if it’s a continuous leak, or does not stop after
pressure has been reached, it might be for one of the following reasons:
1. The nuts and screws on the handle have loosened.
2. The gasket has not been oiled.
1. Make sure the lower handle is screwed tight to the pot before using the
pressure cooker or after the all pressure has been released. Tighten the screws
with a screwdriver if necessary.
2. Make sure you wash and dry your gasket after every use, and oil it regularly.
PROBLEM:
REASON:
SOLUTION:
Pressure does not build up (the visual pressure indicator does not pop up after
more than 5 minutes on high heat).
1. There is not enough liquid.
2. The pressure cooker was not properly closed.
3. The valve is dirty and/or obstructed.
4. The silicone gasket is not in place, or is dirty or worn.
5. The operating valve is not in the correct position.
1. Always use the appropriate amount of liquid called for in the recipe. This amount
should never be less than ½ cup. However, never fill the pressure cooker more
than half full with liquids.
2. Following the instructions given in this manual, close the pressure cooker so
that a tight seal is created, which will allow for adequate pressure build-up.
3. The valve can become dirty when cooking foods such as dried beans which
have a tendency to foam. Clean the valve periodically.
4. Make sure the silicone gasket is clean and well positioned before using the pressure
cooker. After continued use, the silicone gasket will begin to wear and should be
replaced at least once a year if the pressure cooker is used frequently.
5. Make sure the operating valve has been turned to the pressure setting (the
picture of a pot). The pressure cooker will not build up pressure if the operating
valve is turned to the steam release position (the picture of the steam).
ENGLISH
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fagor Splendid at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fagor Splendid in the language / languages: English as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Fagor Splendid

Fagor Splendid User Manual - Spanish - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info