457878
9
Zoom out
Zoom in
Previous page
1/27
Next page
HOW TO INSTALL YOUR OVEN
The power cable (H05 RR-F, H05 RN-F or H05 VV-F) must be of sufficient length to be con-
nected to the build-in oven while it sits on the floor in front of the cabinet.
To do this the appliance must be disconnected from the electrical network:
Open the inspection flap located at the lower right of the back cover by unscrewing the two
screws, then pivot the inspection flap.
Strip 12 mm along each wire of the new power cable.
Carefully twist the strands together.
Loosen the screws from the terminal board and remove the power cord to be replaced.
Insert the power cable through the side of the cover into the cable clip located to the right of
the terminal board.
All the strands of the electrical wires must be secured tightly under the screws.
The phase wire on the L terminal.
The green-yellow coloured earth wire should be connected to the terminal .
The neutral wire (blue) on the N terminal.
----
Connect the wires according to the table on page 7.
Screw down tightly the screws on the terminal board and check the connection by pulling on each
wire.
Attach the cable with the cable clip located to the right of the terminal board.
Close the inspection flap using the two screws.
1
st
CONNECTION OR CHANGE OF THE POWER CABLE
9
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fagor FDO 800X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fagor FDO 800X in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info