514349
11
Zoom out
Zoom in
Previous page
1/16
Next page
11
Maintenance
Before performing any maintenance operation,
isolate the hood from the electrical supply by
switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through
a plug and socket, then the plug must be removed
from the socket.
Grease filter - Fig. 2
The hood has a metal grease filter.
The grease filter serves to trap particles of
grease through suspension.
The metal grease filter lasts forever and must be
washed either by hand or in the dishwasher
(65°C) with suitable detergents.
The grease filters must be washed at least once
a month.
When washed in a dish washer, the grease filter
may discolour slightly, but this does not affect its
filtering capacity.
To remove the metal grease filter
1. Disconnect the hood from the electricity.
2. Push handles A toward the centre.
Carry out the above steps in reverse order to put
the filters back after having washed them, making
sure the entire extraction surface is covered.
Active carbon filter - Fig. 3
The active carbon filter eliminates odours which
are formed during cooking.
If used with normal frequency it should be
replaced once every 6 months.
New active carbon filters are available from the
supplier; it must not be washed.
To dismount the carbon filter:
1. Disconnect the hood from the electricity.
2. Remove the metal filters.
3. Remove exhausted carbon filter, push release
button C and pull carbon filter downwards.
To fit the carbon filter:
1. Fit the carbon filter by sliding it OVER the metal
tabs D and hook it into housings E.
Put the metal filter back into place.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral liquid
detergents. Never use products containing
abrasive.
Wipe brushed stainless steel in the same direction
as the brushing to avoid scratching.
Clean the external surface of the cooker hood
almost once every 10 days.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the filters
may cause fires.
Therefore, we recommend observing these
instructions.
Changing the bulbs
1. Disconnect the hood from the electricity.
2. Open the lampholder compartment by turning
the neon-protecting tabs anti-clockwise (Fig.
3, Q).
3. Always replace burn-out bulbs with olive-
shaped max 40 Watt (E14) bulbs.
4. Close the lampholder.
Before calling for repair service because the
hood fails to light up, make sure the bulbs are
screwed in tightly.
GB
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fagor AF2 627 IX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fagor AF2 627 IX in the language / languages: English, German, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info