Manual Fagor 6H-880ATCX (page 23 of 58) (English, German, Dutch, French, Portuguese, Spanish)

485513

Zoom out

Zoom in

1/58

english

the cooking options display and enter the desired

cooking time. Then select

and enter the end of

cooking time (2.15.8). Validate. The oven will then

go into wait mode until cooking begins (2.15.9).

GRATIN + option. This function is for browning

food. It comes on 5 minutes before the end of

cooking (2.15.10).

Gratin + cannot be used in some cooking modes,

e.g. defrost, maintenance and delicate food.

2.16 Recipe cooking. This function is for cooking

recipes, adjusting the desired amounts according

to the number of people you are cooking for.

Select Recipes on the menu and validate (2.16.1).

6 types of food are available: White meat, Red

meat, Fish, Vegetables, Cakes, Tarts/Quiches.

Select the desired food using

, and

validate (2.16.2). Select the recipe and validate

(2.16.3). Enter the weight and validate (2.16.4).

The oven will recommend a level (2.16.5). Place

the tray at the level and validate. The oven will

automatically make the necessary calculations and

the end of cooking time will appear (2.16.6). When

cooking is complete a beep will sound and the

display will indicate that the dish is ready (2.16.7).

You may change the end of cooking time if you

wish. Press and select Change the time

using , and validate.

2.17 Residual heat

. If the oven is still hot after it has

been switched off,

will appear on the display.

It will only disappear when the temperature inside

the oven drops below 60ºC.

2.18 Automatic switch-off. If you forget to switch

off the oven, it will switch off automatically after

a certain time. If the temperature is lower than

100ºC, the oven will switch off after 10 hours. If the

temperature is higher than 100ºC, it will switch off

after 3 hours.

2.19 Master Chef cooking. This is an intelligent

cooking system. It automatically calculates the time

and temperature cycles using electronic sensors to

measure the humidity and temperature variations.

It has two phases:

Phase 1: Data gathering. The ideal cooking time is

determined. This phase lasts from 5-40 minutes,

depending on the dish. Select Master Chef on

the menu and validate (2.19.1), then choose the

type of dish you wish to cook from the twelve

suggestions and validate (2.19.2). The oven will

indicate the correct tray level. When you have

placed the tray, press

to validate (2.19.3). The

data gathering display will appear (2.19.4), and

will appear during the cooking process.

The Master Chef function does not require pre-

heating. The cooking cycle must start when the

oven is cool. If the oven is hot due to previous use,

you must allow it to cool down.

Important: Do not open the door during this phase

as it will unbalance the calculations and data

gathering.

Phase 2: The data gathering symbol

disappears and the remaining time to end of

cooking appears (2.19.5). When the dish is ready

(2.19.6), the oven switches off and a beep sounds.

To stop the beep, press .

2.20 Low temperature cooking. This function is for

allowing meat to remain tender and more even

cooking. The cooking times are long but the

temperatures are low, and cooking may take up

to 6 hours.

Select Low Temperature on the menu and

validate (2.20.1). Select the type of food to

be cooked from the 6 options and validate

(2.20.2). The oven will suggest you use the low

temperature tray (2.20.3). Validate. The oven will

recommend a level (2.20.4). Validate. The oven will

start cooking with a set time (2.20.5). When this

time has elapsed, (2.20.6) will appear, the oven will

switch off and a beep will sound.

Note: Use the speciﬁ c accessory for low

temperature cooking.

2.21 Memory function. This function enables 3 modes

to be stored in the cooking function. Select

Memories on the menu and validate (2.21.1).

Select Last programme and validate (2.21.2).

The parameters for the last dish cooked will

appear. Validate (2.21.3). Select Save and validate

(2.21.4). Select one of the three memories to store

the parameters in, and validate (2.21.5). (2.21.6)

will appear. Validate. Settings stored (2.21.7)

will appear. The adjustments have now been

stored and you may start the cooking process by

pressing to validate, or exit by pressing .

To use one of the memories stored, select

Memories on the menu and validate (2.21.8).

Select the number of the memory you wish to

use and validate (2.21.9). If the data are correct,

validate (2.21.10) and the oven will start up

(2.21.11).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Fagor 6H-880ATCX in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Fagor 6H-880ATCX Manual

Product: