554725
15
Zoom out
Zoom in
Previous page
1/22
Next page
13
english
1
2
Installation
Using the appliance
To nd out which model your oven is (“a”, “b”,
c”) compare its control panel with the control
panels shown in the illustrations.
Identify the model of your hob (“d”, “e”) by
comparing the number and layout of the elements
on your appliance with that shown in the illustrations.
1.1 Unpacking. Remove all the protective
packaging elements.
1.2 Mains connection. Always take into
account the data on the reference plate
(1.2.1, 1.2.2) and the measurements of the
cabinet the oven will be housed in (1.2.3).
The installation can be made by means
of plugs and sockets or by using the
connecting strip. The maximum amperage
depends on the type of connection. To carry
out the connections, fi rst loosen the two
screws “A” on the oven to obtain access to
the connecting strip (1.2.4).
Hobs:
Stick the foam join along the outer edge of
the hob to make it watertight (1.2.5). Turn the
hob over and insert it into the hole (1.2.6).
Secure it to the unit with the hooks supplied
(1.2.7). Do not use non-removable materials
such as silicone. When the hob has been
installed in the top of the oven recess, the
oven/hob connection cables will be visible.
These cables are encased in a sheath and
end in a male connector “A”. At the rear
of the oven control panel, you will see the
female connector “B” which is for connecting
up the appliances. To make the connection,
proceed as follows:
- Fit the oven into the recess, leaving just
enough space to handle it.
- Fit connectors “A” and “B” together and
connect the appliance to the mains (1.2.8).
Ovens:
Fit the oven into the space, ensuring there
is no excess cable in the upper part (1.2.9,
1.2.10). Screw it to the fi tting using the two
screws supplied (1.2.11). The fi tted furniture
0
Identifi cation
Ovens:
Before using your new oven for the fi rst time,
heat it up while empty (with no food in it and
with the control turned to
, at for 30 minutes
at 250ºC). It may produce some smoke or a bad
smell (this is normal and is caused by the oven
heating up grease residue etc.). When it has
cooled down, pre-clean it by wiping the inside
with a damp cloth.
2.1 Accessories. Depending on the model
there is a Deep Tray (2.1.1), Flat Tray (2.1.2)
and Multifunctional Grill (2.1.3) that work
separately. If it also possible to combine
or its surface must be heat-resistant. The time
must be set in order to fi nish the installation (c).
After a period of inactivity, the machine will turn
to standby and its brightness will diminish or the
screen will switch off, depending on the model.
1.3 Connection to the power supply.
OVEN (2670 W) OVEN (2670 W)
HOB (6200 W) HOB (6700 W)
Voltage
230V~ 230V~
Nominal amperage
by phases
OVEN (2670 W) OVEN (2670 W)
HOB (6200 W) HOB (6700 W)
Voltage
400V~ 400V~
Nominal amperage
by phases
39A 41A
15A 16A
TRIPHASIC Δ
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Fagor 6H-53AX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Fagor 6H-53AX in the language / languages: English, German as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info