649152

Faema E61 Jubile Manual

16
Zoom out
Zoom in
Previous page
1/42
Next page
16
Installazione - Installation - Installation - Installation - Instalación - Instalação
LIGAÇÃO EQÜIPOTENCIAL
Este aparelho está equipado com um borne, colocado
sob a sua base, para a ligação a um condutor externo
eqüipotencial.
Uma vez terminada a instalação é NECESSÁRIO efectuar
este tipo de ligação:
- usar um condutor com uma secção nominal em
conformidade com as normas vigentes;
- ligar o borne, ver a figura.
A falta de cumprimento desta norma de segurança alivia o
fabricante de qualquer responsabilidade por avarias ou
danos que poderiam ser causados a pessoas ou bens.
NOTA: NÃO LIGAR À LIGAÇÃO DE TERRA DA INSTALAÇÃO
DE DISTRIBUIÇÃO ELÉCTRICA ENQUANTO O CONDUTOR
DE LIGAÇÃO DE TERRA NÃO É CONSIDERADO UM
CONDUTOR DE LIGAÇÃO EQÜIPOTENCIAL.
STROMANSCHLUSS MIT POTENTIALAUSGLEICH
Dieses Gerät ist unter dem Untergestell mit einer
Anschlußklemme versehen, die mit einem externen
Stromausgleichsleiter zu verbinden ist.
Nach der Installation MUSS der Stromanschluß wie folgt
vorgenommen werden:
- Einen Leiter verwenden, dessen Nennquerschnitt den
einschlägigen Unfallschutzbestimmungen entspricht;
- ihn wie in der Abbildung gezeigt an die Klemme
anschließen.
Bei Nichtbeachtung dieses Sicherheitshinweises schließt
der Hersteller jedwede Haftungsansprüche für Personen-
oder Sachschäden aus.
HINWEIS: NICHT AN DIE ERDUNG DER
STROMZUFUHRANLAGE ANSCHLIESSEN, DA DER
ERDUNGSLEITER EINES SPEISUNGSKABELS NICHT ALS
AUSGLEICHSLEITER GELTEN KANN.
CONEXION EQUIPOTENCIAL
Este aparato está preajustado con un borne ubicado
debajo de la base para la conexión de un conductor externo
equipotencial.
Una vez terminada la instalación es NECESARIO efectuar
este tipo de conexión:
- usar un conductor con una sección nominal conforme con
las normas vigentes.
- conectar al borne (ver figura).
La falta de respeto de esta norma de seguridad exime al
fabricante de toda responsabilidad por desperfectos o daños
que puedan ser causados a personas o cosas.
NOTA: NO CONECTAR CON LA PUESTA A TIERRA DE LA
INSTALACION DE DISTRIBUCION ELECTRICA DADO QUE EL
CONDUCTOR DE PUESTA A TIERRA EN UN CABLE DE
ALIMENTACION NO ES CONSIDERADO UN CONDUCTOR DE
CONEXION EQUIPOTENCIAL.
POTENTIAL-EQUALIZING CONNECTION
This connection, which is the one called for by several
norms, avoids electrical potential differences building up
between any equipment that may be installed in the same room.
There is a terminal clip on the under side of the base of the
machine to which an external potential-equalizing wire should
be connected.
This connection is ABSOLUTELY NECESSARY and must be
made right after the machine is installed.
- Use a wire whose cross-sectional area conforms to the
existing norms.
- Make the terminal connection (see diagram) and then
connect the other end to the ground connections located
on the adjacent equipment.
Failure to do observe these safety precautions will exempt the
manufacturer from any responsibility as regards damage
caused to persons or property.
NOTE: DO NOT CONNECT THE MACHINE’S TERMINAL CLIP TO
THE MAINS GROUND TERMINAL BECAUSE THE GROUND
TERMINAL OF ANY MAIN SOURCE OF ELECTRICAL POWER IS
NOT CONSIDERED TO BE A POTENTIAL-EQUALIZING
CONNECTION.
CONNEXION EQUIPOTENTIELLE
Ce raccordement, prévu par certaines normes, permet
d'éviter les différences de niveau de potentiel électrique entre
les masses des appareils installés dans une même pièce.
Cet appareil poss de sous sa base d’une borne servant pour
la connexion d’un conducteur externe équipotentiel.
Une fois terminée l’installation, il est NECESSAIRE d’effectuer
ce type de connexion:
- utiliser un conducteur ayant une section nominale
conforme aux normes en vigueur;
- relier à la borne (voir figure) et l'autre extrémité aux masses
des appareils adjacents.
Le non-respect de cette norme de sécurité libère le fabricant
de toute responsabilité en cas de panne ou de dommages
causés aux personnes ou aux choses.
N.B.: NE PAS RELIER A LA TERRE DE L’INSTALLATION DE
DISTRIBUTION ELECTRIQUE CAR LE CONDUCTEUR DE TERRE
D’UN CABLE D’ALIMENTATION N’EST PAS CONSIDERE COMME
ETANT UN CONDUCTEUR DE CONNEXION EQUIPOTENTIEL.
I
GB
COLLEGAMENTO EQUIPOTENZIALE
Questo collegamento previsto da alcune norme, ha la
funzione di evitare le differenze di livello di potenziale elettrico,
tra le masse delle apparecchiature installate nello stesso
locale.
Questo apparecchio è predisposto con un morsetto posto
sotto il basamento per il collegamento di un conduttore esterno
equipotenziale.
Terminata l'installazione è NECESSARIO eseguire questo tipo
di collegamento:
- usare un conduttore avente una sezione nominale in
conformità con le norme vigenti.
- collegare al morsetto (vedi figura) e l'altro capo alle masse
delle apparecchiature adiacenti.
La mancata attuazione di questa norma di sicurezza scagiona
il costruttore da ogni responsabilità per guasti o danni che
possano essere causati a persone o cose.
N.B. NON COLLEGARE ALLA MESSA A TERRA DELL'IMPIANTO
DI DISTRIBUZIONE ELETTRICA IN QUANTO IL CONDUTTORE
DI MESSA A TERRA IN UN CAVO DI ALIMENTAZIONE NON
VIENE CONSIDERATO UN CONDUTTORE DI COLLEGAMENTO
EQUIPOTENZIALE.
F
D
E
P
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faema E61 Jubile at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faema E61 Jubile in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info