EN
EN 9
EN
EN 8
4.5 LIGHTING/EXTINGUISHING THE PILOT LIGHT
Lighting
Turn control knob B to setting | and push it in. Push knob A in a
few times in succession until the pilot light is ignited by a spark. You
will hear a tick. Once the pilot light is alight, keep the knob pushed
in for another 30 seconds. The pilot light will now stay alight.
Extinguishing:
Turn the knob to |, press it in and turn it to the right to
the { setting.
4.6 IF THE PILOT LIGHT GOES OUT
Warning! If the pilot light goes out, wait at least 5 minutes before
relighting it.
Possible causes for the pilot light going out are:
- operation error;
- activation of the oxypilot, caused by improper functioning of the
chimney;
- defect in the pilot system.
4.7 LIGHTING/EXTINGUISHING THE BURNER
Lighting
Turn control knob B to setting 1. The burner will light. The
temperature can be set by turning the knob to the desired setting
between 1 and 7, setting 7 giving the highest temperature.
The slide control can only be used when control knob B has been
turned past the |.
Moving the slide control upwards causes the burner to light. The
further upwards the slide control is set, the higher the flames.
Extinguishing
The thermostatically controlled tap is switched off by setting the
control knob (B) to the left of 1. You can now set the slide control.
The slide control is switched off by sliding it downwards to the {
setting.
When control knob B is turned to the | setting, only the pilot light
continues to burn. Both burners are out.
When control knob B is turned to the { setting, the hearth goes out
completely.
