753234

Faber In-Nova Manual

5
Zoom out
Zoom in
Previous page
1/140
Next page
5
Controls
Button Function Led
LTurns the lights on/off at maximum strength. -
T1 Turns the motor on/off at speed one. Fixed.
Keeping the button pressed for approximately 2 seconds starts/stops the temperature
sensor.
1ashofLEDsT2
and T3 algorithm
activated.
2 ashes of LEDs
T2 and T3 algorithm
deactivated.
T2 Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads
turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The
relevant LED ashes twice to conrm.
To turn the alarm off, press the button again and hold for at least 5 seconds.
The relevant LED ashes once.
Fixed.
T3 Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned
off (Motor and Lights), to perform a reset. The LED S1 ashes three times.
Fixed.
T4 Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated with the
motor turned off, the hood will switch to OFF at the end of the time.
Press and hold for 5 seconds to enable the remote control, indicated by the
LED ashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by the
LED ashing just once.
Fixed.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is necessary
to wash the lters. The alarm is triggered after the Hood has been in operation
for 100 working hours.
Fixed.
When this is activated, it signals the Activated Charcoal Filter saturation alarm,
indicating that the lter must be changed; the Metal Grease Filters must also
be washed. The Activated Charcoal Filter saturation alarm comes into operation
after the Hood has been working for 200 hours.
Flashing.
WARNING: the temperature sensor is active when the hood is started. If, when the hood is off, the tempe-
rature detected by the sensor exceeds the set limit, the hood will turn on at speed two. When the tempe-
rature detected by the sensor returns below the threshold value the hood will turn off. In the event of the
temperature not returning below the threshold value for approximately 90 minutes, the hood will turn off (the
sensor is disabled for approximately 15 minutes, after which it will return to the previous setting). If the hood
is adjusted manually (switching on/changing speed) the sensor is disabled and the hood must be turned off.
After turning the hood off, the sensor is disabled for approximately 15 minutes, after which it will return to
the previous setting. The temperature sensor does not guarantee automatic start-up of the hood, as its
operation is inuenced by environmental conditions, types of cooking operation, height and installation of
the hood (tested at 530 mm).
WARNING: the sensor does not work with induction cookers.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faber In-Nova at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faber In-Nova in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian as an attachment in your email.

The manual is 6,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info