753309
27
Zoom out
Zoom in
Previous page
1/84
Next page
EN 27
USE
Control panel
Turns the motor on/o at speed one, the relevant button LED turns on, and stays
on at all speeds. Press briey to start the motor, if pressed by any speed the motor
turns o.
With all the loads turned o (Motor and Light), if the lters alarm is active, reset
the alarm by pressing this button for approximately 2 seconds: all Leds will ash
3 times.
Turns the Motor on at speed two, the relevant button LED turns on only at 2° speed.
Turns the Motor on at speed three, the relevant button LED turns on only at 3° speed.
• Press and hold the button for approximately 2 seconds to turns the Motor on at IN-
TENSIVE Speed, the LED ashes every 0.5”. This speed is timed to run for 6 minutes.
At the end of this time, the system returns automatically to the speed that was set
before. If it is activated with the motor turned o, it will switch to OFF at the end of
the time. It is deactivated by pressing the same button, or any speed button or the
button to turn o the motor.
Turns the STEAM_SYSTEM on/o (ONLY WITH MOTOR ON); when the SoS is on, the
relevant LED turns on. WHEN THE USERS TURN THE MOTOR OFF, THE SYSTEM
GOES OFF.
With all the loads turned o (Motor and Light),pressing and holding the button for
approximately 2 seconds, the remote control is disabled, indicated by the LED
ashing just once. Pressing again, the remote control is enabled, indicated by the
LED ashing twice.
Turns the lights ON/OFF and also the relevant LED.
FILTERS ALARM
The Metal Grease Filter saturation occurs after the Hood has
been in operation for 100 working hours, indicated by the LED
ashing every 1”
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faber In-nova Touch at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faber In-nova Touch in the language / languages: All languages as an attachment in your email.

The manual is 10,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Faber In-nova Touch

Faber In-nova Touch Installation Guide - All languages - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info