746565
17
Zoom out
Zoom in
Previous page
1/60
Next page
17
GB
FIXING OF REMOTE BLOWER
The xing material supplied with this
kit is suitable for wall xing. In case
the surface is other than wall it is
necessary that the installer uses other
material suitable for that purpose.
Basing on the chosen air outlet
direction remove the screws from the
holes and together with the wall xing
brackets place them again in their
seats on the blower casing.
Mark the hole dots on the xing surface.
Use a ø8 mm drill.
Insert the raw plugs (supplied with the kit).
Fix the blower to the wall using the screws supplied with the kit; it is possible to
correct the levelling of the blower by slightly moving it within the bracket slots.
ELECTRICAL CONNECTION
A 7 m long cable, to be used for the connection between the blower and the
hood, is supplied.
Insert the cable in the grommet supplied with the kit. Place the grommet in it’s
seat and extend the cable until it reaches the hood.
Replace the grommet of the hood mains cable with the grommet supplied with
the blower kit.
The one supplied with the kit has two holes; the rst for the
passage of the hood mains cable and the second for the passage
of the remote blower connection cable.
Take the short cable with 12-position connector from the parts
bag and connect it to the connection cable and consequently to
the motor.
At this point it is advisable to verify the length of the cable
necessary for the connection. The exceeding part can be cut.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faber Heaven 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faber Heaven 2.0 in the language / languages: English, Danish, Italian, Polish, Swedish, Spanish as an attachment in your email.

The manual is 10,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Faber Heaven 2.0

Faber Heaven 2.0 Installation Guide - All languages - 24 pages

Faber Heaven 2.0 User Manual - All languages - 112 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info