752727

Faber Eclipse Manual

9
Zoom out
Zoom in
Previous page
1/112
Next page
EN 9
9
11
2
2
533
116
1÷2
116
650 min.
11
12a
590
300
290
12a
Vr
Drilling the Wall and Fixing the Motor unit
Given the complexity of installation operations, they should be carried out by at least two people.
If the hood is fitted in the recirculation version, bear in mind that there must be a minimum distance of at least
8-10 Cm left between the top of the hood and the surface above it (ceiling or shelf).
Draw the following on the Wall:
• a Vertical line up to the ceiling or top surface, at the centre of the area in which the Hood is to be fitted;
• a Horizontal line: 650 mm min. above the Cooker Top.
• As shown in the drawing, mark a reference point (1) 116 mm from the vertical reference line, and 533
mm above the horizontal reference line.
• Repeat this operation on the other side, checking to ensure it is level.
• Drill the points marked using a ø 8 mm drill bit.
• Insert the plugs 11 into the holes.
• Tighten the 2 screws 12a (4.2 x 44.4) provided in the bores, leaving a gap of 5-6 mm between the wall
and the heads of the screws.
• Lock the 2 screws Vr located on the connection points for the Motor unit 3.
• Hook the Motor unit 3 to the screws 12a.
• Turn screws Vr to level the hood canopy.
• Mark the reference points (2) for the brackets hooked under the Motor unit 3, as shown.
• Drill the points marked using a ø 8 mm drill bit.
• Insert the plugs 11 into the holes.
• Insert 2 of the screws 12a (4.2 x 44.4) provided into the bores.
• Tighten the 4 screws 12a fixing the Suction Unit completely.
Rear Ducting Outlet
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faber Eclipse at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faber Eclipse in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 5,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info