753250
3
Zoom out
Zoom in
Previous page
1/96
Next page
3
Recommendations
and suggestions
The Instructions for Use apply
to several versions of this appli-
ance. Accordingly, you may nd
descriptions of individual features
thatdo notapply toyourspecic
appliance.
The manufacturer will not be held
liable for any damages resulting
from incorrect or improper instal-
lation.
The minimum safety distance
between the cooker top and the
extractor hood is 650 mm (some
models can be installed at a
lower height, please refer to the
paragraphs on working dimensions
and installation).
Check that the mains voltage
corresponds to that indicated on
theratingplatexedtotheinside
of the hood.
For Class I appliances, check that
the domestic power supply guaran-
tees adequate earthing. Connect
the extractor to the exhaust ue
through a pipe of minimum diam-
eter 120 mm. The route of the
uemustbeasshortaspossible.
Do not connect the extractor hood
to exhaust ducts carrying combus-
tionfumes(boilers,replaces,etc.).
If the extractor is used in conjunc-
tion with non-electrical appliances
(e.g. gas burning appliances),
a sufcient degree of aeration
must be guaranteed in the room
in order to prevent the backow
of exhaust gas. The kitchen must
have an opening communicating
directly with the open air in order
to guarantee the entry of clean air.
When the cooker hood is used
in conjunction with appliances
supplied with energy other than
electric, the negative pressure in
the room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by the
cooker hood.
In the event of damage to the
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
If the instructions for installation
for the gas hob specify a greater
distancespeciedabove,thishas
to be taken into account. Regula-
tions concerning the discharge of
air have to be fullled.
Use only screws and small parts
in support of the hood.
Warning: Failure to install the
screwsorxingdeviceinaccord-
ance with these instructions may
result in electrical hazards.
Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
Use
The extractor hood has been
designed exclusively for domestic
use to eliminate kitchen smells.
Never use the hood for purposes
other than for which it has been
designed.
Never leave high naked ames
under the hood when it is in op-
eration.
Adjusttheameintensitytodirect
it onto the bottom of the pan only,
making sure that it does not engulf
EN
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Faber Carre at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Faber Carre in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian as an attachment in your email.

The manual is 8,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info